As a potential therapy for periodontitis, sodium ampicillin, a broad spectrum antibiotic, was adsorbed onto hydroxyapatite (HA) and glass-reinforced hydroxyaptite (GR-HA) composites, and was subsequently released in vitro. The sodium ampicillin, was adsorbed more on HA compared to the GR-HA composites. X-ray di!raction (XRD) and Rietveld analysis were used to identify and quantify the levels of HA and -tricalcium phosphate ( -TCP) in the microstructure of the GR-HA composites. Lattice parameters changes were observed for the -TCP phase dependant on the amount of glass added. The release kinetics were shown to be divided into three stages, the "rst of which where a large amount of sodium ampicillin is released, followed by a slower release rate and then a "nal stage where the release amount approaches zero, until no more sodium ampicillin was present. X-ray photoeletron spectroscopy (XPS) studies were carried out in order to ensure that the entire antibiotic adsorbed onto the materials had been released. These kinetics studies have indicated the possibility of using these materials as possible carriers for drug delivery.

No abstract

No abstract

Several studies were carried out in order to reduce the systemic use of antibiotics due to the high concentration required to provide the minimum inhibitory concentration (MIC) at infected sites. The aim of this study was to develop a system of drug adsorption onto commercial hydroxyapatite (HA, Ca 10 (PO 4 ) 6 (OH) 2 ) and glass reinforced hydroxyapatite (GR-HA) granules. The drug will then be released for the local treatment of periodontitis. The antibiotics used in this study were metronidazole, a specific antibiotic indicated for the systemic treatment of periodontitis, and ampicillin, a wide spectrum antibiotic. UV spectroscopy was used to measure the amount of drug adsorbed onto HA and GR-HA granules. Results showed that metronidazole was unable to adsorb on the material's surface, as opposed to ampicillin which adsorbed both onto HA and GR-HA. Preliminary release kinetics studies were carried out using a flow through dissolution system. Results are discussed in terms of the influence of the different surface characteristics of the materials on the adsorption processes. C 2005 Springer Science + Business Media, Inc.