Biodegradable materials are under investigation due to their promising properties for biomedical applications as implant material. In the present study, two binary magnesium (Mg) alloys (Mg2Ag and Mg10Gd) and pure Mg (99.99%) were used in order to compare the degradation performance of the materials in in vitro to in vivo conditions. In vitro analysis of cell distribution and viability was performed on discs of pure Mg, Mg2Ag and Mg10Gd. The results verified viable pre-osteoblast cells on all three alloys and no obvious toxic effect within the first two weeks. The degradation rates in in vitro and in vivo conditions (Sprague-Dawley® rats) showed that the degradation rates differ especially in the 1st week of the experiments. While in vitro Mg2Ag displayed the fastest degradation rate, in vivo, Mg10Gd revealed the highest degradation rate. After four weeks of in vitro immersion tests, the degradation rate of Mg2Ag was significantly reduced and approached the values of pure Mg and Mg10Gd. Interestingly, after 4 weeks the estimated in vitro degradation rates approximate in vivo values. Our systematic experiment indicates that a correlation between in vitro and in vivo observations still has some limitations that have to be considered in order to perform representative in vitro experiments that display the in vivo situation.

The purpose of this study was to compare short term in vitro and in vivo biodegradation studies with low purity Mg (> 99.94 %), Mg-10Gd and Mg-2Ag designed for biodegradable implant applications. Three in vitro testing conditions were applied, using (i) phosphate buffered saline (PBS), (ii) Hank's balanced salt solution (HBSS) and (iii) Dulbecco's modified eagle medium (DMEM) in 5 % CO 2 under sterile conditions. Gas evolution and mass loss (ML) were assessed, as well as the degradation layer, by elemental mapping and scanning electron microscopy (SEM). In vivo, implantations were performed on male Sprague-Dawley rats evaluating both, gas cavity volume and implant volume reduction by micro-computed tomography (µCT), 7 d after implantation. Samples were produced by casting, solution heat treatment and extrusion in disc and pin shape for the in vitro and in vivo experiments, respectively. Results showed that when the processing of the Mg sample varied, differences were found not only in the alloy impurity content and the grain size, but also in the corrosion behaviour. An increase of Fe and Ni or a large grain size seemed to play a major role in the degradation process, while the influence of alloying elements, such as Gd and Ag, played a secondary role. Results also indicated that cell culture conditions induced degradation rates and degradation layer elemental composition comparable to in vivo conditions. These in vitro and in vivo degradation layers consisted of Mg hydroxide, Mg-Ca carbonate and Ca phosphate.

No abstract

No abstract

No abstract