No abstract

This research details a novel method of increasing the shear yield stress of magnetorheological (MR) fluids by combining shear and squeeze modes of operation to manipulate particle chain structures, to achieve so-called compression-assisted aggregation. The contribution of both active gap separation and particle concentration are experimentally measured using a custom-built Searle cell magnetorheometer, which is a model device emulating a rotary Magnetorheological Energy Absorber (MREA). Characterization data from large (1 mm) and small (250 μm) gap geometries are compared to investigate the effect of the gap on yield stress by compression enhancement. Two MR fluids having different particle concentrations (32 vol% and 40 vol%) are also characterized to demonstrate the effect of solids loading on compression-assisted chain aggregation. Details of the experimental setup and method are presented, and a chain microstructure model is used to explain experimental trends. The torque resisted by practical rotary MREAs is directly related to the strength of the MR fluid used, as measured by the shear yield stress. This study demonstrates that it is feasible, utilizing the compression-enhanced shear yield stress, to either (1) design a rotary MREA of a given volume to achieve higher energy absorption density (energy absorbed normalize by device volume), or (2) reduce the volume of a given rotary MREA to achieve the same energy absorption density.

Elastic percolation transition in nanowire-based magnetorheological fluids Appl. Phys. Lett. 95, 014102 (2009); 10.1063/1.3167815 Dynamic yield stress enhancement in bidisperse magnetorheological fluids J. Rheol. 49, 1521 (2005); 10.1122/1.2085175Study on the mechanism of the squeeze-strengthen effect in magnetorheological fluids

No abstract

Articles you may be interested inRheological characterization of a magnetorheological ferrofluid using iron nitride nanoparticles Magnetorheological behavior of magnetite covered clay particles in aqueous suspensions J. Appl. Phys. 112, 043917 (2012); 10.1063/1.4748878Magnetorheology and sedimentation behavior of an aqueous suspension of surface modified carbonyl iron particles Magnetorheological (MR) fluids are suspensions of micron-scale magnetizable particles suspended in a carrier fluid. When field is applied, MR fluids develop a field controllable yield stress and a field independent post-yield viscosity. However, this viscosity has substantial temperature dependence, varying by up to an order of magnitude over the operating temperature range of MR fluid devices. We apply non-Brownian suspension theory to explain this result and find that the majority of this effect should be caused by the temperature dependent behavior of the carrier fluid. Thus, if two fluids share the same carrier fluid, then their fluid properties should scale in temperature similarly. This result is first validated by measuring viscosity across temperature for custom model fluids designed to conform to theory, showing temperature scaling within 5% for both the MR fluids and their carrier fluid. Then, on a series of related commercially available fluids with unknown additive content, we show that the MR fluids exhibit common scaling to within 4%. We also investigate the effects of magnetic hysteresis and find that it induces a negligible increase in yield stress and no measurable change in viscosity. We conclude that our non-dimensional analysis enables the temperature dependence of novel MR fluids to be characterized with fewer experiments. V C 2015 AIP Publishing LLC. [http://dx.