Rapid synthesis of ultralong silver nanowires (AgNWs) has been obtained using a one-pot polyol-mediated synthetic procedure. The AgNWs have been prepared from the base materials in less than one hour with nanowire lengths reaching 195 μm, which represents the quickest synthesis and one of the highest reported aspect ratios to date. These results have been achieved through a joint analysis of all reaction parameters, which represents a clear progress beyond the state of the art. Dispersions of the AgNWs have been used to prepare thin, flexible, transparent and conducting films using spray coating. Due to the higher aspect ratio, an improved electrical percolation network is observed. This allows a low sheet resistance (RS = 20.2 Ω/sq), whilst maintaining high optical film transparency (T = 94.7%), driving to the highest reported figure-of-merit (FoM = 338). Owing to the light-scattering influence of the AgNWs, the density of the AgNW network can also be varied to enable controllability of the optical haze through the sample. Based on the identification of the optimal haze value, organic photovoltaics (OPVs) have been fabricated using the AgNWs as the transparent electrode and have been benchmarked against indium tin oxide (ITO) electrodes. Overall, the performance of OPVs made using AgNWs sees a small decrease in power conversion efficiency (PCE), primarily due to a fall in open-circuit voltage (50 mV). This work indicates that AgNWs can provide a low cost, rapid and roll-to-roll compatible alternative to ITO in OPVs, with only a small compromise in PCE needed.

An overview of the effects produced by the presence of hydrogen in a glow discharge (GD), generated either in argon or in neon, is given. Extensive work related to the addition of hydrogen to GDs, coupled with optical emission spectrometry (OES) and mass spectrometry (MS), has been published in the last few years in an attempt to explain the processes involved in the discharge of mixed gases. Although numerous experimental results have already been explained theoretically, a complete understanding of the effects brought about by mixing hydrogen with argon (or another discharge inert gas) has not been reported yet. The use of theoretical models implemented using a computer has allowed the importance of some collisional and radiative processes in the inert gas plasma when hydrogen is present to be evaluated. This review shows, however, that both experimental work and theoretical work are still needed. The influence of small quantities of hydrogen on discharge parameters, such as electrical current or dc bias voltage, on crater shapes and on sputtering rates is thoroughly reviewed along with the effect on the analytical signals measured by OES and MS. Also, hydrogen-effect corrections needed to carry out proper calibrations for direct solid quantitative analyses are discussed.

The analytical potential of ArF* excimer Laser Ablation Inductively Coupled Plasma Mass Spectrometry (LA-ICP-MS) is investigated for fast qualitative depth profile analysis of multi-layer CdTe photovoltaic (PV) devices.

No abstract

No abstract