No abstract

Motivated by the success of using graphene oxide (GO) as a nanofiller of composites, there is a drive to search for this new kind of carbon material as a bioactive component in ceramic materials. In the present study, biomineralized GO was prepared by two different approaches, represented by in situ sol-gel synthesis and biomimetic treatment. It was found that in the biocomposites obtained by the sol-gel approach, the spindle-like hydroxyapatite nanoparticles, with a diameter of ca. 5 ± 0.37 nm and a length of ca. 70 ± 2.5 nm, were presented randomly and strongly on the surface. The oxygen-containing functional groups, such as hydroxyl and carbonyl, present on the basal plane and edges of the GO sheets, play an important role in anchoring calcium ions, as demonstrated by FT-IR and TEM investigations. A different result was obtained for biocomposites after biomimetic treatment: an amorphous calcium phosphate on GO sheet was observed after 5 days of treatment. These different approaches resulted in a diverse effect on the proliferation and differentiation of osteogenic mesenchymal stem cells. In fact, in biocomposites prepared by the sol-gel approach the expression of an early marker of osteogenic differentiation, ALP, increases with the amount of GO in the first days of cell culture. Meanwhile, biomimetic materials sustain cell viability and proliferation, even if the expression of alkaline phosphatase activity in a basal medium is delayed. These findings may provide new prospects for utilizing GO-based hydroxyapatite biocomposites in bone repair, bone augmentation and coating of biomedical implants and broaden the application of GO sheets in biological areas. Copyright © 2016 John Wiley & Sons, Ltd.

Surface plasmon resonance-based gas sensor with chalcogenide glass and bimetallic alloy nanoparticle layer An extension of the Mie ͓Ann. Phys. 25, 377 ͑1908͔͒ theory for the calculation of optical absorption spectra in bimetallic nanoparticles has been developed. The nanoparticle dielectric function is assumed to be a weighted linear combination of dielectric functions for single particles. Accordingly, analytical expressions for the resonance light absorption frequency, the spectrum maximum value, and the full width at half maximum have been derived, taking into account the interband transitions in the dielectric functions. Experiments have been performed on polymer-embedded Ag/ Au nanoparticles prepared by reducing the presence of poly͑vinyl pyrrolidone͒ at room temperature. Experimental absorption spectra have been compared to numerical curves derived by the model in the case of Ag/ Au systems at different relative compositions, and they are in good agreement. The time dependence of both Ag/ Au nanoparticle size and chemical composition during the growth process has also been investigated.

The design, fabrication, and characterization of a minimally invasive silicon microchip for transdermal injection/sampling applications are reported and discussed. The microchip exploits an array of silicon-dioxide hollow microneedles with density of one million needles cm(-2) and lateral size of a few micrometers, protruding from the front-side chip surface for one hundred micrometers, to inject/draw fluids into/from the skin. The microneedles are in connection with independent reservoirs grooved on the back-side of the chip. Insertion experiments of the microchip in skin-like polymers (agarose hydrogels with concentrations of 2% and 4% wt) demonstrate that the microneedles successfully withstand penetration without breaking, despite their high density and small size, according to theoretical predictions. Operation of the microchip with different liquids of biomedical interest (deionized water, NaCl solution, and d-glucose solution) at different differential pressures, in the range 10-100 kPa, highlights that the flow-rate through the microneedles is linearly dependent on the pressure-drop, despite the small section area (about 13 μm(2)) of the microneedle bore, and can be finely controlled from a few ml min(-1) up to tens of ml min(-1). Evaporation (at room temperature) and acceleration (up to 80 g) losses through the microneedles are also investigated to quantify the ability of the chip in storing liquids (drug to be delivered or collected fluid) in the reservoir, and result to be of the order of 70 nl min(-1) and 1300 nl min(-1), respectively, at atmospheric pressure and room temperature.