Trimethylamine (TMA) is one of the important chemical indexes to judge the freshness of marine fish. It is necessary to develop a low temperature TMA sensor to help the monitoring and prediction of the quality of marine fish in cold chain. Herein, a flexible low temperature TMA gas sensor featuring antifreezing and superior mechanical properties was developed based on the Au nanoparticle-modified MXene (MXene@Au) composite. MXene@Au was synthesized and then polymerized with a hydrogel composed of acrylamide (AM), N,N′-methylenebisacrylamide (BIS), sodium carboxymethyl cellulose (CMC), and EG, and the resultant MXene@Au hydrogel was found to exhibit excellent antifreezing performance even at extremely low temperature as well as high tensile strength, ultrastretchability, and toughness, which enabled an efficient gas sensing platform for TMA detection at low temperature. The TMA sensing properties of the flexible MXene@Au DN hydrogel sensor at 25 °C and a low temperature of 0 °C were studied, and a linear relationship between TMA sensitivity and concentration was built. The excellent sensing properties were maintained even under deformation. The application of the MXene@Au DN hydrogel sensor in detection of fish freshness at 0 °C was investigated. The result indicated the potential application of the flexible MXene@Au DN hydrogel gas sensor in dynamic quality monitoring and prediction of marine fish products during its transportation and storage in the cold chain.

No abstract

No abstract

Cost management and scalable fabrication without sacrificing the purification performance are two critical issues that should be addressed before the practical commercial application of solar-driven evaporators. To address this challenge, we report a porous photothermal hydrogel coating prepared by mixing the raw materials of sawdust (SD), carbon nanotubes (CNTs), and poly­(vinyl alcohol) (PVA), which was applied to undergo a blading–drying–rehydration process to prepare the evaporator. In the coating, the crystallized PVA gives the coating a solid skeleton and the sawdust endows the coating with a loose structure to sufficiently enhance the water transportation capacity. As a result, the evaporator coated with the hydrogel coating displays a high water transport rate and efficient evaporation performance along with excellent mechanical properties and stability. Water migrates vertically upward 5 cm within 4 minutes. The compressive stress of the rehydrated hydrogel coating reaches as high as 14.28 MPa under 80% strain. The water evaporation rate of the hydrogel coating-based evaporator reaches 1.833 kg m–2 h–1 corresponding to an energy efficiency of 83.29% under 1 sun irradiation. What is more, the hydrogel coating retains its excellent evaporation performance and stability after immersion in acid or alkali solution, ultrasound treatment, and long-time immersion in water. Under outdoor conditions, the water evaporation rate of the hydrogel coating-based evaporator is about 5.69 times higher than that of pure water. This study proposes a rapid, cost-effective, and scalable strategy for preparing a high-performance photothermal hydrogel coating that will find sustainable and practical application in solar-driven water purification.

No abstract