This review aims to determine how head shape is measured and describes the use of orthoses in the management of deformational plagiocephaly. A systematic review was conducted and papers published in English up to and including 2006 were sourced from nine databases. After initial screening, 20 papers were included; three literature reviews and 17 original papers. Of the original papers, eight concerned the method of head shape measurement.

Background: The UK will host the Paralympics in 2012 and the Commonwealth Games in 2014 showcasing the talents of elite athletes and aiming to inspire the population to become involved. However, low levels of physical activity are prevalent: only 40% of men and 28% of women meet the minimum UK physical activity recommendations. The population of people with limb absence is no exception. Objectives: To determine if people with amputation are participating in physical activity and sport; whether post-amputation activity levels match pre-amputation levels; and if there are motivations and barriers to participation. Study Design: Literature review. Methods: Five reviewers systematically searched all peer reviewed and gray literature in seven bibliographic databases and the Cochrane Library. Results: Following rigorous elimination, 12 articles were finally included in the review and critically appraised. Four themes were identified: components; rehabilitation outcomes; body image; and motivations and barriers to participation. Conclusion: People with limb absence are not participating in physical activity conducive to health benefits, and only a minority participate in exercise and sports. Participation following amputation does not mirror that of pre-amputation levels, and more barriers than motivations exist to adopting or maintaining a physically active lifestyle. Clinical relevance This literature review aims to inform those involved in rehabilitation and ongoing care of those with limb absence about what motivates or precludes their participation in physical activity, exercise and sport. Such knowledge could be applied to improving health and wellbeing in this population.

Background: Disability is inextricably linked to poverty. A total of 80% of the disabled population lives in low-income countries. The demand for prosthetic and orthotic services in these countries is increasing, and a variety of methods to provide services are currently used. Objectives: To assess current models of provision to facilitate sustainable, evidence-based prosthetic and orthotic services. Study Design: Literature review. Methods: A literature search was performed through Medline (Ovid), PubMed, ISI Web of Knowledge, EMBASE and RECAL Legacy using combinations of subject heading and text word searching strategies. Full-text publications were critically appraised and ranked according to the Scottish Intercollegiate Guidelines Network guidelines. Results: Three areas were deemed pertinent to the research question. Studies were grouped into one or more of these categories based on the issues addressed: instigators, types of service provision, demographics and region-specific issues. It was found that many complex factors influence prosthetic and orthotic services in low-income countries. Demographic and regional idiosyncrasies require prosthetic and orthotic services to be tailored to address the specific needs of individual countries. Conclusions:The lack of and quality of available research made efficacy of methods used to provide services in low-income countries difficult to determine. Clinical relevanceThis review aims to highlight areas of best practice in prosthetic and orthotic services in low-income countries and to show where further research is required in order to develop evidence-based prosthetic and orthotic services.

No abstract

Introduction: In trans-tibial prosthetics, shape-capture methods are employed to create a representation of the residuum. Shape-capture methods can be grouped into the categories of ‘hands-on’, ‘hands-off’ and computer-aided design. Objective: This review examines the influences and trends of shape-capture methods on the outcomes of quality, comfort of user and clinical efficiency, in the population of trans-tibial prosthesis users. Study Design: Systematic Review Method: Databases and relevant journals were searched. Participants included trans-tibial prosthetics users/limb models. Interventions included shape-capture methods. Outcomes included quality, comfort of user and clinical efficiency. Results: Overall, 22 papers were evaluated; 8 papers evaluated hands-on and hands-off methods, 2 evaluated computer-aided design and 12 evaluated measurement systems used with shape capture. No papers relating to clinical efficiency were found. Conclusion: Overall evidence was weak in suggesting that effects on outcomes were due to the sole influences of shape capture. However, studies suggest that hands-on methods are dependent on a prosthetist’s skill. Hands-off methods, although repeatable, might still require experience to attain a good fit. Computer-aided design studies were mostly done on theoretical models. Shape-capture measurements require more consistent ‘gold standards’. The relation between socket fit and comfort is still unclear. Overall, more research is required in each area. Clinical relevance A good fitting prosthetic socket is crucial for efficient and comfortable use of a prosthesis. To attain the best chances of a good fit, it is important that the characteristics of the residuum are captured as accurately as possible during the initial “shape capture” stage. This paper attempts to categorize and evaluate the existing shape capture methods on their influence and trends on various outcomes - Quality of shape capture, comfort of user and clinical efficiency.