Large-scale distributed Multiuser MIMO (MU-MIMO) is a promising wireless network architecture that combines the advantages of "massive MIMO" and "small cells." It consists of several Access Points (APs) connected to a central server via a wired backhaul network and acting as a large distributed antenna system. We focus on the downlink, which is both more demanding in terms of traffic and more challenging in terms of implementation than the uplink. In order to enable multiuser joint precoding of the downlink signals, channel state information at the transmitter side is required. We consider Time Division Duplex (TDD), where the downlink channels can be learned from the user uplink pilot signals, thanks to channel reciprocity. Furthermore, coherent multiuser joint precoding is possible only if the APs maintain a sufficiently accurate relative timing and phase synchronization.AP synchronization and TDD reciprocity calibration are two key problems to be solved in order to enable distributed MU-MIMO downlink. In this paper, we propose novel over-the-air synchronization and calibration protocols that scale well with the network size. The proposed schemes can be applied to networks formed by a large number of APs, each of which is driven by an inexpensive 802.11grade clock and has a standard RF front-end, not explicitly designed to be reciprocal. Our protocols can incorporate, as a building block, any suitable timing and frequency estimator. Here we revisit the problem of joint ML timing and frequency estimation and use the corresponding Cramer-Rao bound to evaluate the performance of the synchronization protocol. Overall, the proposed synchronization and calibration schemes are shown to achieve sufficient accuracy for satisfactory distributed MU-MIMO performance.

Abstract-The enormous success of advanced wireless devices is pushing the demand for higher wireless data rates. Denser spectrum reuse through the deployment of more Access Points (APs) per square mile has the potential to successfully meet the increasing demand for more bandwidth. In principle, distributed multiuser MIMO (MU-MIMO) provides the best approach to infrastructure density increase, since several access points are connected to a central server and operate as a large distributed multi-antenna access point. This ensures that all transmitted signal power serves the purpose of data transmission, rather than creating interference. In practice, however, a number of implementation difficulties must be addressed, the most significant of which is aligning the phases of all jointly coordinated APs.In this paper we propose AirSync, a novel scheme which provides timing and phase synchronization accurate enough to enable distributed MU-MIMO. AirSync detects the slot boundary such that all APs are time-synchronous within a cyclic prefix (CP) of the OFDM modulation, and predicts the instantaneous carrier phase correction along the transmit slot such that all transmitters maintain their coherence, which is necessary for multiuser beamforming. We have implemented AirSync as a digital circuit in the FPGA of the WARP radio platform. Our experimental testbed, comprised of four APs and four clients, shows that AirSync is able to achieve timing synchronization within the OFDM CP and carrier phase coherence (after the correction) within a few degrees. For the purpose of demonstration, we have implemented two MU-MIMO precoding schemes, Zero-Forcing Beamforming (ZFBF) and Tomlinson-Harashima Precoding (THP). In both cases our system approaches the theoretical optimal multiplexing gains. We also discuss aspects related to the MAC and multiuser scheduling design, in relation to the distributed MU-MIMO architecture. To the best of our knowledge, AirSync offers the first ever realization of the full distributed MU-MIMO multiplexing gain, namely the ability to increase the number of active wireless clients per time-frequency slot linearly with the number of jointly coordinated APs, without reducing the per client rate.

A distributed MIMO system consists of several access points connected to a central server and operating as a large distributed multi-antenna access point. In theory, such a system enjoys all the significant performance gains of a traditional MIMO system, and it may be deployed in an enterprise WiFi like setup. In this paper, we investigate the efficiency of such a system in practice. Specifically, we build upon our prior work on developing a distributed MIMO testbed, and study the performance of such a system when both full channel state information is available to the transmitters and when no channel state information is available.In the full channel state information scenario, we implement Zero-Forcing Beamforming (ZFBF) and TomlinsonHarashima Precoding (THP) which is provably near-optimal in high SNR conditions. In the scenario where no channel information is available, we implement Blind Interference Alignment (BIA), which achieves a higher multiplexing gain (degrees of freedom) than conventional TDMA. Our experimental results show that the performance of our implementation is very close to the theoretically predicted performance and offers significant gains over optimal TDMA. We also discuss medium access layer issues in detail for both scenarios. To the best of our knowledge, this is the first time that the theoretical high data rates of multiuser MIMO systems have been showcased in a real world distributed MIMO testbed.

No abstract