The global shift towards renewable energy is manifested in developing countries such as Ethiopia primarily because of continuous economic growth in the last two decades and secondly due to the vast untapped potential resources. In addition to other factors, the lack of accurate data of the resources has, however, hampered the development of solar energy technologies. The aim of this paper is to investigate the resource estimation by undertaking direct measurements at selected sites in the Northern part of Ethiopia. This paper presents an assessment of the solar energy resource based on the primary data collected between January 2011 and December 2012. The daily and monthly average global solar radiation is analyzed based on the 10 minute interval measurement retrieved from the data loggers. From the analysis it is seen that the measured values give a better accuracy and distribution of the global solar radiation than earlier Fig.s that were based on satellite images and model calculations. Furthermore, these results can be used to determine the solar resource potential of Northern Ethiopia for further energy development.

To meet sustainable development goals and address concerns on climate change, much of the world's energy demand is expected to be delivered from clean alternative energy sources. Small-scale wind turbines have proven to be applicable for off-grid electrification. The objective of this study is to present the details on the design and manufacture of a 1 kW wind turbine blade for specified conditions. Blade element moment theory is adopted in the design of the geometry of the blade. Accordingly, the aerodynamic analysis on NACA 64A410 airfoil resulted in a blade radius of 1.95m, an overall twist angle of 31°, and a gradually tapering chord length of 0.062m at the root and 0.247m at the tip of the blade. Then, the wind turbine blades are manufactured from fiberglass (mat350g), resin, catalyst, and gelcoat.  Experimental results reveal the wind turbine blades started producing power at a cut-in wind speed of 3m/s. The maximum power achieved during the testing process was 900W at a hub wind velocity of 9m/s. This is lower than the expected 1000W theoretical power output due to not perfect workmanship in the manufacture of the wind turbine blades. This study will help in building local manufacturing facilities and enhance rural electrification through off-grid technologies.