Carbon nanotubes (CNTs) and carbon nanofibers (CNFs) are quickly becoming two of the most promising nanomaterials because of their unique mechanical properties. The size and aspect ratio of CNFs and CNTs mean that they can be distributed on a much finer scale than commonly used microreinforcing fibers. As a result, microcracks are interrupted much more quickly during propagation in a nanoreinforced matrix, producing much smaller crack widths at the point of first contact between the moving crack front and the reinforcement. In this study, untreated CNTs and CNFs are added to cement matrix composites in concentrations of 0.1 and 0.2% by weight of cement. The nanofilaments are dispersed by using an ultrasonic mixer and then cast into molds. Each specimen is tested in a custom-made three-point flexural test fixture to record its mechanical properties; namely, the Young's modulus, flexural strength, ultimate strain capacity, and fracture toughness, at 7, 14, and 28 days. A scanning electron microscope (SEM) is used to discern the difference between crack bridging and fiber pullout. Test results show that the strength, ductility, and fracture toughness can be improved with the addition of low concentrations of either CNTs or CNFs.

Carbon nanofibers (CNFs) and nanotubes (CNTs) are known to be extremely strong and stiff, and their potential as reinforcement has been of interest to many investigators in the past decade. One of the most important keys for fully harnessing the properties of any type of fiber is to control the distribution in the material matrix. As far as CNFs–CNTs are concerned, the strong attraction among nanoscale fibers due to van der Waals forces makes this task difficult. This study focuses on some of the problems that prevent a uniform distribution of CNFs–CNTs in cement paste and the methods used in the past to enhance dispersion. The first phase of the experimental program investigates the effect of using superplasticizers accompanied by sonication on the dispersion of CNFs in water and paste. The second phase focuses on the problem of cement grain size and limitations that the use of fine grain cement causes. Finally, on the basis of results and past studies, suggestions are made for achieving enhanced dispersion of CNFs–CNTs in cement paste.

For the last three decades, fiber reinforced polymer (FRP) composite materials have been widely used in major engineering industries. Managing FRP waste is becoming an important issue due to the growth in the production of FRP composite materials. In this article, the issue of FRP waste management is discussed and the commonly used methods for the handling of FRP waste are reviewed. One potentially viable use of FRP waste is in the partial replacement of fillers or aggregates in cementitious materials (particularly portland cement mortar and concrete). A number of important prior investigations performed on the use of FRP waste in concrete and mortar are reviewed. The results from most of those investigations suggest that FRP aggregates significantly reduce the strength of cementitious materials with little significant effect on durability. Recommendations for future research in this area are provided for producing stronger mortars and concretes incorporating FRP production and end-of-life waste.

No abstract

Abstract:The very rapid growth in wind energy technology in the last 15 years has led to a rapid growth in the amount of non-biodegradable, thermosetting fiber reinforced polymer (FRP) composite materials used in wind turbine blades. This paper discusses conceptual architectural and structural options for recycling these blades by reusing parts of wind turbine blades in new or retrofitted housing projects. It focuses on large-sized FRP pieces that can be salvaged from the turbine blades and can potentially be useful in infrastructure projects where harsh environmental conditions (water and high humidity) exist. Since reuse design should be for specific regional locations and architectural characteristics the designs presented in this paper are for the coastal regions of the Yucatan province in Mexico on the Gulf of Mexico where low-quality masonry block informal housing is vulnerable to severe hurricanes and flooding. To demonstrate the concept a prototype 100 m long wind blade model developed by Sandia National Laboratories is used to show how a wind blade can be broken down into parts, thus making it possible to envision architectural applications for the different wind blade segments for housing applications.