No abstract

No abstract

Finite element analyses are conducted to model the tensile capacity of steel fiber-reinforced concrete (SFRC). For this purpose dog-bone specimens are casted and tested under direct and uniaxial tension. Two types of aggregates (brick and stone) are used to cast the SFRC and plain concrete. The fiber volume ratio is maintained 1.5 %. Total 8 numbers of dog-bone specimens are made and tested in a 1000-kN capacity digital universal testing machine (UTM). The strain data are gathered employing digital image correlation technique from high-definition images and high-speed video clips. Then, the strain data are synthesized with the load data obtained from the load cell of the UTM. The tensile capacity enhancement is found 182-253 % compared to control specimen to brick SFRC and in case of stone SFRC the enhancement is 157-268 %. Fibers are found to enhance the tensile capacity as well as ductile properties of concrete that ensures to prevent sudden brittle failure. The dog-bone specimens are modeled in the ANSYS 10.0 finite element platform and analyzed to model the tensile capacity of brick and stone SFRC. The SOLID65 element is used to model the SFRC as well as plain concretes by optimizing the Poisson's ratio, modulus of elasticity, tensile strength and stress-strain relationships and also failure pattern as well as failure locations. This research provides information of the tensile capacity enhancement of SFRC made of both brick and stone which will be helpful for the construction industry of Bangladesh to introduce this engineering material in earthquake design. Last of all, the finite element outputs are found to hold good agreement with the experimental tensile capacity which validates the FE modeling.

Timber is widely used as a structural element because of its engineering and mechanical properties. This study focuses on the flexural behavior of timber beams externally reinforced with carbon fiber reinforced polymer (CFRP) composites at the tension face and the responses of the fundamental principal compression arch because of confinement from end anchorage. Beams of three different types of timber are studied. All the beams had the same length, width, and span length and were tested under four-point loading. Different CFRP lamination techniques were adopted, with and without U-clamp confinement as end anchorage, to investigate the flexural capacity enhancement of CFRP strips as reinforcement for timber beams. The profile of the principal compression arch is estimated experimentally from fundamental flexural strain-along-depth phenomena by post-processing high definition images extracted from test videos employing digital image correlation technique (DICT) in the MATLAB R2011a framework. Similar responses were found from finite element analysis using ANSYS 11.0. Effective confinement of the principal compression arch produced significant enhancements of flexural capacities and stiffness in the strengthened timber beams.