No abstract

Imaging or beam-steering systems employing a periodic array of microlenses or micromirrors suffer from diffraction problems resulting from the destructive interference of the beam segments produced by the array. Simple formulas are derived for beam steering with segmented apertures that do not suffer from diffraction problems because of the introduction of a moving linear phase shifter such as a prescan lens before the periodic structure. The technique substantially increases the resolution of imaging systems that employ microlens arrays or micromirror arrays. Theoretical, numerical, and experimental results demonstrating the high-resolution imaging concept using microlens arrays are presented.

High-resolution imaging and beam steering using 3 microlens arrays (MLA) is demonstrated. Small lateral displacement of one microlens array is sufficient for large angle beam steering. A prescan lens is added to the system to overcome the discrete addressing problem associated with microlens scanning systems. A hybrid method that uses both geometrical ray tracing optimization and physical optics simulation is introduced for the design and optimization of the MLA system. Feasibility of 1880 x 1880 resolution using f/2 aspherical MLAs and 752 x 752 resolution using f/5 spherical MLAs are demonstrated assuming 100 microm microlens pitch and 2mm clear aperture. The system is compact and suitable for endoscopic imaging and agile steering of large beams.

Fill-factor of microlens arrays (MLAs) is one of the most important performance criteria of microlens arrays (MLA), especially in imaging applications. Low fill-factor lenses suffer greatly from spurious light and diffraction affects and result in low contrast in a beam steering system. Contrast ratio of low fill-factor circular shaped microlens arrays is nearly one-fourth of that of the system with high fill-factor square shaped microlens arrays. In this study performance of various types of nearly 100% fill-factor spherical MLAs in beam steering applications are compared. Design and fabrication of the MLAs are studied. A new hybrid method for design and fabrication of 100% fill-factor MLAs-by combining refractive-diffractive lenses, is suggested and tested.