Increasingly accurate life prediction models are required to utilize the full capability of current and future advanced materials in gas turbine engines. Of particular recent interest are predictions of the lifetimes of engine airfoil materials that experience significant intervals of high-frequency, high-cycle fatigue (HCF). Conventional life management practices for HCF in the turbine engine industry have been based principally on a total-life approach. There is a growing need to develop damage tolerance methods capable of predicting the evolution and growth of HCF damage in the presence of foreign object damage (FOD), low cycle fatigue (LCF), and surface fretting fatigue.To help identify key aspects of the HCF life prediction problem for turbine engine components, a review is presented of the extensive results of an Air Force research contract with Pratt & Whitney on the high strength titanium alloy Ti-8AI-IMo-IV. Data from this representative turbine-airfoil material are used to examine the applicability of linear elastic fracture mechanics methods for prediction of service lifetimes under load spectra that include high cycle fatigue. The roles of fatigue crack initiation and growth are examined for materials that are nominally-defect-free, as well for materials that have experienced significant prior structural damage. An assessment is presented of the potential utility of the conventional threshold stress intensity factor range, AKth, defined by testing specimens containing large cracks. Although the general utility of a large-crack-AKth approach is questionable due to the potentially rapid growth of small fatigue cracks, the low allowable stresses involved in turbine engine high cycle fatigue appear to limit and simplify the small-crack problem. An examination is also presented of the potential effects of high-cycle fatigue and low-cycle fatigue (HCF/LCF) interactions.

No abstract

No abstract

No abstract

Fatigue crack growth studies have been conducted on a two-phase alloy with a nominal composition of Ti-46.5Al-3Nb-2Cr-0.2W (at. pct), heat treated to produce duplex and lamellar microstructures. Fatigue crack growth tests were conducted at 23 ЊC using computer-controlled servohydraulic loading at a cyclic frequency of 20 Hz. Several test methods were used to obtain fatigue crack growth rate data, including decreasing-load-range-threshold, constant-load-range, and constant-K max increasingload-ratio crack growth control. The lamellar microstructure showed substantial improvement in crack growth resistance and an increase in the threshold stress intensity factor range, ⌬K th , when compared with the behavior of the duplex microstructure. The stress ratio had a significant influence on crack growth behavior in both microstructures, which appeared to be a result of roughness-induced crack closure mechanisms. Fractographic characterization of fatigue crack propagation modes indicated a highly tortuous crack path in the fully lamellar microstructure, compared to the duplex microstructure. In addition, limited shear ligament bridging and secondary cracking parallel to the lamellar interfaces were observed in the fully lamellar microstructure during fatigue crack propagation. These observations were incorporated into a model that analyzes the contribution of intrinsic vs extrinsic mechanisms, such as shear ligament bridging and roughness-induced crack closure, to the increased fatigue crack growth resistance observed for the fully lamellar microstructure.