In this paper, Energy, Entropy and Exergy (EEE) analysis of flat plate solar collector is studied through a mathematical model by considering the overall loss coefficient as a non-constant parameter. The overall loss coefficient is calculated by minimizing the top loss coefficient using Lagrange multiplier optimization technique and also by empirical formulas. Further, energy efficiency, entropy generation, exergy destruction and exergy efficiency of the flat plate solar collector are also determined for the both aforesaid overall loss coefficients. The exergy efficiency of the proposed model has been doubled, when compared with the experimental measurements in the earlier literature. Also, comparing the proposed methods, it is observed that exergy efficiency obtained by using the minimal top loss coefficient is reasonably high and it enhances the overall collector’s efficiency.

Today, the applications of sprays cover a wide range of fields. Their role in internal combustion engines is instrumental in maintaining higher engine efficiency. A deeper understanding of the liquid-gas phase interaction in sprays is crucial to the atomization process. The methods and models used in the simulations have their challenges due to the various discretization schemes and solutions used. To develop and validate the computational models, well defined experimental data is required. In the present work, spray characteristics were studied numerically through OpenFOAM. As the spray characteristics are closely linked with the liquid breakup length, this study focuses on the primary breakup phenomena and the breakup length of the liquid jet emanating from the twin-fluid co-axial flow atomizer. Numerical simulations were performed for a wide range of initial conditions and the breakup length of the spray was validated against the experimental observed by Sivadas et al., [26]. These simulations were carried out using a Eulerian based VOF solver that models the fluid as a continuum. K-Epsilon model was used to predict the turbulent nature of the spray. The air and water velocities were varied between 19.0 to 31.3 m/s and 0.7 to 1.8 m/s respectively. The proposed model was able to predict the computed breakup length within 20% of the experimental values. The present model can be further extended to test for a co-axial swirl injector to predict finer spray formation.

This study investigates the hidden thermal losses of glass plate, collector plate, water pipe and storage tank of solar water heater in the process of energy conversion. The present non-conventional energy methods are insufficient, whereas the exergy analysis provides a remarkable solution. Thus, employing the exergy analysis, entropy generation, exergy destruction and exergy efficiency of each subsystem of solar water heater are computed. The obtained results showed that the entropy generation and exergy destruction are high during the heat transfer in each subsystem. Henceforth, the existing solar water heater design is modified placing hexagonal honeycomb structure between the glass plate and the collector plate and also water pipe is insulated to trap huge amount of solar energy. The proposed design exhibits improved exergy efficiency when compared with the existing model, which enhances the performance of the system.

No abstract