Plasma catalysis is gaining increasing interest for CO2 conversion, but the interaction between the plasma and catalyst is still poorly understood. This is caused by limited systematic materials research, since most works combine a plasma with commercial supported catalysts and packings. In the present paper, we study the influence of specific material and reactor properties, as well as reactor/bead configuration, on the conversion and energy efficiency of CO2 dissociation in a packed bed dielectric barrier discharge (DBD) reactor. Of the various packing materials investigated, BaTiO3 yields the highest conversion and energy efficiency, i.e., 25% and 4.5%.Our results show that, when evaluating the influence of catalysts, the impact of the packing (support) material itself cannot be neglected, since it can largely affect the conversion and energy efficiency. This shows the large potential for further improvement of packed bed plasma reactors for CO2 conversion and other chemical conversion reactions by adjusting both packing (support) properties and catalytically active sites. Moreover, we clearly prove that comparison of results obtained in different reactor setups should be done with care, since there is a large effect of the reactor setup and reactor/bead configuration.

The complex of halothane (CHClBrCF(3)) and dimethyl ether has been investigated experimentally in solutions of liquid krypton using infrared spectroscopy and theoretically using ab initio calculations at the MP2/6-311++G(d,p) level. The formation of a 1:1 complex was experimentally detected. The most stable ab initio geometry found is the one in which the C--H bond of halothane interacts with the oxygen atom of dimethyl ether. The complexes in which the chlorine or the bromine atom of halothane interacts with the oxygen atom of the ether were found to be local energy minima and were less stable by 14.5 and 9.3 kJ mol(-1), respectively, than the global minimum. The formation of a single complex species was observed in the infrared spectra; the standard complexation enthalpy of this complex was determined to be -12.3(8) kJ mol(-1). Analysis of the observed complexation shifts supports the identification of the complex as the hydrogen-bonded species. The C--H stretching vibration of halothane was found to show a redshift upon complexation of 19(2) cm(-1). The infrared intensity ratios epsilon(complex)/epsilon(monomer) for the fundamental and its first overtone were measured to be 6.5(1) and 0.31(1). The frequency shift was analyzed using Morokuma-type analysis, and the infrared intensity ratios were rationalized using a model including the mechanical and electric anharmonicity of the C--H stretching fundamental.

The formation of C-H...π bonded complexes of halothane with benzene(-d(6)) has been studied using infrared and Raman spectroscopy of solutions in liquid krypton, in supersonic jet expansions and in room temperature vapour phase. The formation of complexes with 1 ∶ 1 and 2 ∶ 1 stoichiometry was observed. The complexation enthalpy in liquid krypton for the 1 ∶ 1 complex was determined to be -9.8(2) kJ mol(-1) and the enthalpy for the addition of a second halothane molecule to the 1 ∶ 1 complex was determined at -7.0(3) kJ mol(-1). The stretching mode of the halothane C-H bond involved in the formation of the complex in the jets was observed to blue shift by 7.7(10) cm(-1). In contrast, for the solutions of liquid krypton and the room temperature measurements a small red shift was observed. Supported by ab initio calculations and Monte Carlo simulations, this shift was explained by the differences in thermal populations of the van der Waals vibrations of the complex in the different experiments.

No abstract

No abstract