Conventional gel electrodes are widely used for biopotential measurements, despite important drawbacks such as skin irritation, long set-up time and uncomfortable removal. Recently introduced dry electrodes with rigid metal pins overcome most of these problems; however, their rigidity causes discomfort and pain. This paper presents dry electrodes offering high user comfort, since they are fabricated from EPDM rubber containing various additives for optimum conductivity, flexibility and ease of fabrication. The electrode impedance is measured on phantoms and human skin. After optimization of the polymer composition, the skin-electrode impedance is only ∼10 times larger than that of gel electrodes. Therefore, these electrodes are directly capable of recording strong biopotential signals such as ECG while for low-amplitude signals such as EEG, the electrodes need to be coupled with an active circuit. EEG recordings using active polymer electrodes connected to a clinical EEG system show very promising results: alpha waves can be clearly observed when subjects close their eyes, and correlation and coherence analyses reveal high similarity between dry and gel electrode signals. Moreover, all subjects reported that our polymer electrodes did not cause discomfort. Hence, the polymer-based dry electrodes are promising alternatives to either rigid dry electrodes or conventional gel electrodes.

Monitoring human brain activity has great potential in helping us understand the functioning of our brain, as well as in preventing mental disorders and cognitive decline and improve our quality of life. Noninvasive surface EEG is the dominant modality for studying brain dynamics and performance in real-life interaction of humans with their environment. To take full advantage of surface EEG recordings, EEG technology has to be advanced to a level that it can be used in daily life activities. Furthermore, users have to see it as an unobtrusive option to monitor and improve their health. To achieve this, EEG systems have to be transformed from stationary, wired, and cumbersome systems used mostly in clinical practice today, to intelligent wearable, wireless, convenient, and comfortable lifestyle solutions that provide high signal quality. Here, we discuss state-of-the-art in wireless and wearable EEG solutions and a number of aspects where such solutions require improvements when handling electrical activity of the brain. We address personal traits and sensory inputs, brain signal generation and acquisition, brain signal analysis, and feedback generation. We provide guidelines on how these aspects can be advanced further such that we can develop intelligent wearable, wireless, lifestyle EEG solutions. We recognized the following aspects as the ones that need rapid research progress: application driven design, end-user driven development, standardization and sharing of EEG data, and development of sophisticated approaches to handle EEG artifacts.

Early mental stress detection can prevent many stress related health problems. This study aimed at using a wearable sensor system to measure physiological signals and detect mental stress. Three different stress conditions were presented to a healthy subject group. During the procedure, ECG, respiration, skin conductance, and EMG of the trapezius muscles were recorded. In total, 19 physiological features were calculated from these signals. After normalization of the feature values and analysis of correlations among these features, a subset of 9 features was selected for further analysis. Principal component analysis reduced these 9 features to 7 principal components (PCs). Using these PCs and different classifiers, a consistent classification accuracy between stress and non stress conditions of almost 80% was found. This suggests that a promising feature subset was found for future development of a personalized stress monitor.

Stress is a growing problem in society and can, amongst others, induce musculoskeletal complaints, related to sustained muscle tension. The ability to measure stress with a wireless system would be useful in the prevention of stress-related health problems. The aim of this experiment was to derive stress levels of subjects from electromyography (EMG) signals of the upper trapezius muscle. Two new stress tests were designed for this study, which aimed at creating circumstances that are similar to work stress.An experiment is described in which EMG signals of the upper trapezius muscle were measured during three different stressful situations. Stress tests included a calculation task (the Norinder test), a logical puzzle task and a memory task, of which the last two were newly designed.The results show significantly higher amplitudes of the EMG signals during stress compared to rest and fewer gaps (periods of relaxation) during stress. Also, mean and median frequencies were significantly lower during stress than during rest. The differences in EMG features between rest and stress conditions indicate that EMG is a useful parameter to detect stress. These results show opportunities for the inclusion of EMG sensors in a wireless system for ambulatory monitoring of stress levels.