In electromagnetic forming of thin sheet metal, the die is located within the effective range of the electromagnetic wave. Correspondingly, a current is induced not only in the sheet metal, but also in the die. Like the current in the workpiece, also the current in the die interacts with the electromagnetic wave, resulting in Lorentz forces and changes of the electromagnetic field. With the aim to study the influence of different electromagnetic die properties in terms of specific electric resistance and relative magnetic permeability, electromagnetic simulations were carried out. A change in the resulting forming forces in the sheet metals was determined. To confirm the simulation results, electromagnetic forming and embossing tests were carried out with the corresponding die materials. The results from simulation and experiment were in good agreement.

No abstract

Electromagnetic forming is a high-speed process, which features contactless force transmission. Hence, punching operations can be realized with a one-sided die and without a mechanical punch. As the forces act as body forces in the part near the surface, the process is especially convenient for embossing microstructures on thin sheet metals. Nevertheless, the die design is critical concerning wear like adhesion. Several die materials were tested, like aluminum, copper as well as different steel types. For all die materials adhesion phenomena were observed. To prevent such adhesion an a-C:H-PVD (Physical Vapor Deposition)-coating was applied to steel dies (X153CrMoV12) and tested by embossing aluminum sheets (Al99.5). By this enhancement of the die adhesion was prevented. Furthermore, the die surface was structured with tribology-effective patterns that were generated by micro hard milling. The embossing quality was topographically analyzed with respect to different initial surface states of the sheets. It was identified that thicker sheets facilitate better embossing results. Moreover, the initial sheet surface has a decisive influence on the embossing quality, whereby the characteristic of the topography showed different susceptibility on the initial sheet surface state.

Electromagnetic forming is a contactless high-speed forming technique. In this process force transmission is initiated by an electromagnetic field provided by a tool coil. While forming thin sheet metal, the magnetic field is present in the whole depth of the sheet metal by definition. Thus, the magnetic field generates eddy currents in the complete sheet volume. The resulting Lorenz` forces act as body forces and are used for forming. Thereby high strain rates, high temperatures and multiaxial stress fields influence the plastic material properties of the workpiece. In this study, the plastic properties were investigated under real electromagnetic forming conditions. By varying process conditions like charge energy, sheet thickness and die material, the magnetic field and thus the plastic material properties were changed. To visualize the influence of the electromagnetic field, forming experiments were carried out. The strain of the formed sheets was measured. Furthermore, the forming forces were determined by measurements during the electromagnetic forming as well as by finite element simulations. With the measured strain and the determined forming force, a model for the plastic material behavior during electromagnetic forming was evolved.

Electromagnetic embossing enables the transfer of surface structures from forming dies to metal sheets at high forming speeds. For this purpose, the contactless forming force is provided by means of a magnetic field of a tool coil which interacts with an eddy current in the workpiece. In thin sheets which are completely penetrated by the magnetic field, the resulting Lorentz forces act as body forces that accelerate the workpiece onto the forming die. In addition to the body forces, also high strain rates can support the embossing of thin sheets. This investigation deals with the embossing of pyramidal structures in the submillimeter range and an aspect ratio of about 1 into thin aluminum sheets (3.0255 / Al99,5). In order to quantify the reproduced microstructures, their extent is determined by means of a lateral analysis. From this, the replicated height is derived. Up to now it has been possible to partially reproduce microstructures with a large aspect ratio in thin sheets. In addition, the changing surface roughness of the sheets is taken into account. Before embossing, the sheets exhibit a relatively rough surface with a rolled texture, which is smoothed by the impulse forming with an optical forming die. This study reveals basic approaches for the electromagnetic embossing of optical microstructures.