The purpose of this study was to develop poly(lactic acid)-methacrylic acid copolymeric nanoparticles with the potential to serve as nanocarrier systems for methotrexate (MTX) used in the chemotherapy of primary central nervous system lymphoma (PCNSL). Nanoparticles were prepared by a double emulsion solvent evaporation technique employing a 3-Factor Box-Behnken experimental design strategy. Analysis of particle size, absolute zeta potential, polydispersity (Pdl), morphology, drug-loading capacity (DLC), structural transitions through FTIR spectroscopy, and drug release kinetics was undertaken. Molecular modelling elucidated the mechanisms of the experimental findings. Nanoparticles with particle sizes ranging from 211.0 to 378.3 nm and a recovery range of 36.8–86.2 mg (Pdl ≤ 0.5) were synthesized. DLC values were initially low (12 ± 0.5%) but were finally optimized to 98 ± 0.3%. FTIR studies elucidated the comixing of MTX within the nanoparticles. An initial burst release (50% of MTX released in 24 hours) was obtained which was followed by a prolonged release phase of MTX over 84 hours. SEM images revealed near-spherical nanoparticles, while TEM micrographs revealed the presence of MTX within the nanoparticles. Stable nanoparticles were formed as corroborated by the chemometric modelling studies undertaken.

The purpose of this study was to design, characterize and assess the influence of triethanolamine (TEA) on the physicomechanical properties and release of methotrexate (MTX) from a composite biopolymeric membrane. Conjugated poly(L-lactic acid) (PLLA) and poly(vinyl alcohol) (PVA) membranes were prepared by immersion precipitation with and without the addition of TEA. Drug entrapment efficiency (DEE) and release studies were performed in phosphate buffered saline (pH 7.4, 37 degrees C). Scanning electron microscopy elucidated the membrane surface morphology. Computational and structural molecular modeling rationalized the potential mechanisms of membrane formation and MTX release. Bi-axial force-distance (F-D) extensibility profiles were generated to determine the membrane toughness, elasticity and fracturability. Membranes were significantly toughened by the addition of TEA as a discrete rubbery phase within the co-polymer matrix. MTX-TEA-PLLA-PVA membranes were tougher (F = 89 N) and more extensible (D = 8.79 mm) compared to MTX-PLLA-PVA (F = 35 N, D = 3.7 mm) membranes as a greater force of extension and fracture distance were required (N = 10). DEE values were relatively high (>80%, N = 5) for both formulations. Photomicrographs revealed distinct crystalline layered morphologies with macro-pores. MTX was released by tri-phasic kinetics with a lower fractional release of MTX from MTX-TEA-PLLA-PVA membranes compared to MTX-PLLA-PVA. TEA provided a synergistic approach to improving the membrane physicomechanical properties and modulation of MTX release. The composite biopolymeric membrane may therefore be suitable for the novel delivery of MTX in the treatment of chronic primary central nervous system lymphoma.