Purpose The purpose of this paper is to provide an overview of the design and experimental work of compliant wing and wingtip morphing devices conducted within the EU FP7 project NOVEMOR and to demonstrate that the optimization tools developed can be used to synthesize compliant morphing devices. Design/methodology/approach The compliant morphing devices were “designed-through-optimization”, with the optimization algorithms including Simplex optimization for composite compliant skin design, aerodynamic shape optimization able to take into account the structural behaviour of the morphing skin, continuum-based and load path representation topology optimization methods and multi-objective optimization coupled with genetic algorithm for compliant internal substructure design. Low-speed subsonic wind tunnel testing was performed as an effective means of demonstrating proof-of-concept. Findings It was found that the optimization tools could be successfully implemented in the manufacture and testing stage. Preliminary insight into the performance of the compliant structure has been made during the first wind tunnel tests. Practical implications The tools in this work further the development of morphing structures, which when implemented in aircraft have potential implications to environmentally friendlier aircrafts. Originality/value The key innovations in this paper include the development of a composite skin optimization tool for the design of highly 3D morphing wings and its ensuing manufacture process; the development of a continuum-based topology optimization tool for shape control design of compliant mechanisms considering the stiffness and displacement functions; the use of a superelastic material for the compliant mechanism; and wind tunnel validation of morphing wing devices based on compliant structure technology.

General rightsThis document is made available in accordance with publisher policies. Please cite only the published version using the reference above.

No abstract

Morphing is a technology with high potential to reduce emissions in aviation, since it enables wings to adapt their shape to operate at a higher efficiency over the full range of flight conditions. This paper is presenting a concept to adapt camber by drooping the nose. The scope is the setup and bench top testing of a full scale wing tip leading edge wind tunnel model with a morphing droop nose. The complete model features a span of 1.3 m and a strong taper from the root to the tip. For completeness, the design approach is covered as well. The design comprises a GFRP skin to be drooped by two compliant mechanisms, which are driven by linear motors. The compliant morphing devices are “designed-through-optimization”, with the optimization algorithms including Simplex optimization for composite compliant skin design, continuum-based and load path representation topology optimization methods for compliant internal substructure design. The compliant mechanism is manufactured by nickel-titanium alloy to allow high strains in the order of several percent, which is shown to be critical in the design of such compliant mechanisms. In order to validate the models, strains within the mechanisms are measured while drooping the nose in the bench top test. This is done after installing the mechanisms into the leading edge skin. It can be shown, that the simulation for the inboard mechanism is close to the experimental results. The comparison of strain levels in the skin and in the mechanism during droop reveals that the stiffness distribution between these two components is quite different. As a result this ratio can be taken into account in future design processes in order to distribute strains more evenly. Moreover the 3D shapes of the morphed and clean skin are measured and their comparison with the target shapes is presented as well. Finally, the bench top tests are a proof of concept for the overall concept and design which resultes in a “go” for the following low speed subsonic wind tunnel tests.

No abstract