The light-harvesting properties of cationic conjugated polymers are used to sensitize the emission of a dye on a specific peptide nucleic acid (PNA) sequence for the purpose of homogeneous, ''real-time'' DNA detection. Signal transduction is controlled by hybridization of the neutral PNA probe and the negative DNA target. Electrostatic interactions bring the hybrid complex and cationic polymer within distances required for Fö rster energy transfer. Conjugated polymer excitation provides fluorescein emission >25 times higher than that obtained by exciting the dye, allowing detection of target DNA at concentrations of 10 pM with a standard fluorometer. A simple and highly sensitive assay with optical amplification that uses the improved hybridization behavior of PNA͞DNA complexes is thus demonstrated.

A sensor is provided that detects single-stranded deoxyribonucleic acid (ssDNA) with a specific base sequence. The ssDNA sequence sensor comprises an aqueous solution containing a cationic water-soluble conjugated polymer [in this case, poly(9,9-bis(6'-N,N,N-trimethylammonium)-hexyl)-fluorene phenylene), 1] with a ssDNA labeled with a dye (in this case, fluorescein). The emission of light from the sensor solution with the wavelength characteristic of the probe oligonucleotide indicates the presence of ssDNA with a specific base sequence complementary to that of the probe ssDNA-fluorescein. Maximum energy transfer from 1 to the signaling chromophore occurs when the ratio of polymer chains to DNA strands is approximately 1:1. Energy transfer from 1 results in a fluorescein emission that is more intense than that observed by direct excitation of the chromophore. Furthermore, the decrease in energy transfer upon addition of electrolyte indicates that electrostatic forces dominate the interactions between 1 and DNA.

Fluorescence spectra show that excitation of the cationic water-soluble conjugated polymer poly[(1,4-phenylene)-2,7-[9,9-bis(6'-N,N,N-trimethylammonium)-hexyl]fluorene diiodide] (1) results in inefficient fluorescence resonance energy transfer (FRET) to ethidium bromide (EB) intercalated within double-stranded DNA (dsDNA). When fluorescein (Fl) is attached to one terminus of the dsDNA, there is efficient FRET from 1 through Fl to EB. The cascading energy-transfer process was examined mechanistically via fluorescence decay kinetics and fluorescence anisotropy measurements. These experiments show that the proximity and conformational freedom of Fl provide a FRET gate to dyes intercalated within DNA which are optically amplified by the properties of the conjugated polymer. The overall process provides a substantial improvement over previous homogeneous conjugated polymer based DNA sensors, namely, in the form of improved selectivity.

What enhances the energy transfer between oppositely charged polyelectrolytes in water? To evaluate this, the authors synthesized oligo‐ and polymeric counterions (see Figure for an example of a polycation) and measured fluorescence quenching. The effect was biggest for polymers in the presence of a large excess of surfactant, stressing the influence of supramolecular aggregation of the chromophores.

The synthesis of 1,4-bis(9,9'-bis(3"-(N,N,N-trimethylammonium)-propyl)-2'-fluorenyl)benzene tetrabromide (C3), 1,4-bis(9,9'-bis(4"-(N,N,N-trimethylammonium)-butyl)-2'-fluorenyl)benzene tetrabromide (C4), 1,4-bis(9,9'-bis(6"-(N,N,N-trimethylammonium)-hexyl)-2'-fluorenyl)benzene tetrabromide (C6), and 1,4-bis(9,9'-bis(8"-(N,N,N-trimethylammonium)-octyl)-2'-fluorenyl)benzene tetrabromide (C8) is reported. Fluorescence energy transfer experiments between C3-C8 and the acceptors pentasodium 1,4-bis(4'(2",4"-bis(butoxysulfonate)-styryl)styryl)-2-(butoxysulfonate)-5-methoxybenzene (3), fluorescein labeled single-stranded DNA and fluorescein labeled double-stranded DNA in water, buffer, and methanol reveal the importance of hydrophobic and electrostatic forces in determining chromophore-chromophore close proximity. In water, the oligomers with longer side chain length show better energy transfer, as well as higher Stern-Volmer quenching constants (K(sv)), largely due to a stronger hydrophobic attraction between the optically active components. In methanol, the differences in energy transfer are leveled, and the oligomers with shorter side chain lengths show higher K(sv) values. Compounds C3, C4, C6, and C8 were also used to dissect the different contributors to DNA hybridization assays based on cationic conjugated polymers.