No abstract

Experiments were conducted to study peculiarities of drop impact onto electrospun polymer nanofiber mats. The nanofiber cross-sectional diameters were of the order of several hundred nanometers, the pore sizes in the mats of about several micrometers, and the mat thicknesses of the order of 200 microm. Polyacrylonitrile (PAN), a polymer which is partially wettable by water, was used to electrospin nanofiber mats. The experiments revealed that drop impact onto nanotextured surfaces of nanofiber mats produce spreading similar to that on the impermeable surfaces. However, at the end of the spreading stage, the contact line is pinned and drop receding is prevented. At higher impact velocities, prompt splashing events with formation of tiny drops were observed. It was shown that the splash parameter K(d) = We(1/2) Re(1/4) (with We and Re being the Weber and Reynolds numbers, respectively) previously used to characterize the experiments with drop impact onto smooth impermeable dry substrates can be also used to describe the onset of splash on substrates coated by nanofiber mats. However its threshold value K(ds) (in particular, corresponding to the minimal impact velocity leading to generation of secondary droplets) for the nanotextured surfaces is higher than that for dry flat substrates. In addition, water penetration and spreading inside wettable nanofiber mats after drop impact was elucidated and quantified. The hydrodynamics of drop impact onto nanofiber mats is important for understanding effective spray cooling through nanofiber mats, recently introduced by the same group of authors.

The impact of a drop onto a liquid film with a relatively high impact velocity, leading to the formation of a crown-like ejection, is studied theoretically. The motion of a kinematic discontinuity in the liquid film on the wall due to the drop impact, the formation of the upward jet at this kinematic discontinuity and its elevation are analysed. Four main regions of the drop and film are considered: the perturbed liquid film on the wall inside the crown, the unperturbed liquid film on the wall outside the crown, the upward jet forming a crown, and the free rim bounding this jet. The theory of Yarin & Weiss (1995) for the propagation of the kinematic discontinuity is generalized here for the case of arbitrary velocity vectors in the inner and outer liquid films on the wall. Next, the mass, momentum balance and Bernoulli equations at the base of the crown are considered in order to obtain the velocity and the thickness of the jet on the wall. Furthermore, the dynamic equations of motion of the crown are developed in the Lagrangian form. An analytical solution for the crown shape is obtained in the asymptotic case of such high impact velocities that the surface tension and the viscosity effects can be neglected in comparison to inertial effects. The edge of the crown is described by the motion of a rim, formed due to the surface tension.Three different cases of impact are considered: normal axisymmetric impact of a single drop, oblique impact of a single drop, and impact and interaction of two drops. The theoretical predictions of the height of the crown in the axisymmetric case are compared with experiments. The agreement is quite good in spite of the fact that no adjustable parameters are used.

No abstract

No abstract