No abstract

There is considerable interest in portable emissions measurement systems (PEMS) for emission inventory and regulatory applications. For this study, four commercial PEMS were compared with a Federal Reference Method (FRM) for measuring emissions from a back-up generator (BUG) over steady-state loads and a diesel truck on transient and steady-state chassis dynamometer tests. The agreement between the PEMS and the FRM varied depending on the pollutant and the particular PEMS tested for both the BUG and chassis dynamometer testing. The best performing PEMS for both the BUG and chassis testing was within approximately 12% for NOx of the FRM. For the BUG testing, several PEMS showed agreement with the FRM within approximately 5% for CO2. For the chassis dynamometer testing, the best PEMS showed agreement typically within approximately 5% for CO2. PM measurements for the BUG testing were low compared to the FRM, with the best measurements approximately 20% lower. For the chassis testing, two PM PEMS showed a good correlation but a high bias, while the correlation was worse for the other two PEMS. For each emissions component, some PEMS under different test conditions showed considerably larger deviations than those for the best performing PEMS.

Current SAE practices for evaluating potential improvements in fuel economy on heavy-duty vehicles rely on gravimetric measurements of fuel tanks. However, the recent evolution of portable emissions measurement systems (PEMS) offers an alternative means of evaluating real-world fuel economy that may be faster and more cost effective. This paper provides a direct comparison of these two methods based on a recent EPA study conducted at Southwest Research Institute. More than 228 on-road tests were performed on two pairs of class 8 tractor-trailers according to SAE test procedure J1321 in an assessment of various chassis components designed to reduce drag losses on the vehicle. During these tests, SEMTECH-D™ portable emissions measurement systems from Sensor's, Incorporated were operating in each of the vehicles to evaluate emissions and to provide a redundant measure of fuel economy. These measurements showed excellent correlation to the gravimetric results with a coefficient of determination greater than 0.98 and nearly identical regression slopes for three of the four trucks. One truck had a series of suspect data toward the end of the study that biased the regression slope higher by 4%. Measurement variability also compared favorably between the two test methods. The average coefficient of variation based on the three repeat laps performed on every test segment was 2.98% for the gravimetric measurements and 3.26% for the SEMTECH-D measurements at a 95% confidence interval. These results all support the use of SEMTECH-D as a viable alternative to the gravimetric measurements for heavyduty in-use fuel economy determination.

No abstract

Reducing aerodynamic drag and tire rolling resistance in trucks using cooled EGR engines meeting EPA 2004 emissions standards has been observed to result in increases in fuel economy and decreases in NOx emissions. We report here on tests conducted using vehicles equipped a non-EGR engine meeting EPA 2004 emission standards and an electronicallycontrolled engine meeting EPA 1998 emissions standards. The effects of trailer fairings and single-wide tires on fuel economy and NOx emissions were tested using SAE test procedure J1321. NOx emissions were measured using a portable emissions monitoring system (PEMS). Fuel consumption was estimated by a carbon balance on PEMS output and by the gravimetric method specified by test procedure J1321. Fuel consumption decreased and fuel economy increased by a maximum of about 10 percent, and NOx emissions decreased by a maximum of 20 percent relative to baseline. This compares with NOx reductions of up to 45 percent reported in the earlier test on the cooled EGR engine. The reduction in power requirements in the current test did not result in a corresponding reduction in brake specific NOx emissions, as it did in the earlier test. These results provide further evidence that reducing parasitic losses in heavy-duty highway vehicles will not only reduce fuel consumption and greenhouse gas emissions, but will also provide NOx reductions that pay for themselves through reduced fuel use.