No abstract

No abstract

Water absorption and thermomechanical behavior of composites based on thermoplastic starch (TPS) are presented in this work, wherein the concentration of agave bagasse fibers (ABF, 0–15 wt%) and poly(lactic acid) (PLA, 0–30 wt%) is varied. Glycerol (G) is used as starch (S) plasticizer to form TPS. Starch stands as the polymer matrix (70/30 wt/wt, S/G). The results show that TPS hygroscopicity decreases as PLA and fiber content increase. Storage, stress-strain, and flexural moduli increase with PLA and/or agave bagasse fibers (ABF) content while impact resistance decreases. The TPS glass transition temperature increases with ABF content and decreases with PLA content. Micrographs of the studied biocomposites show a stratified brittle surface with a rigid fiber fracture.

Foamed linear medium density polyethylene parts were prepared by rotational molding in biaxial mode, using different amounts of chemical-blowing agent (azodicarbonamide). Morphological and mechanical properties are presented and discussed in terms of foam density, cell density, average cell diameter, and open cell content. Internal air temperature of the mold was measured as a function of time. Significant differences were observed between unfoamed and foamed parts. The use of an exothermic chemical-blowing agent increased the peak internal air temperature and part cooling was slower due to the presence of gas bubbles acting as insulating material. The most important changes were observed for foam density: adding 1 phr of azodicarbonamide the density decreased from 0.931 g/cm3 (0 phr azodicarbonamide) to 0.295 g/cm3. Finally, the mechanical properties were highly influenced by azodicarbonamide content. Tensile and impact properties were correlated with part density using a simple power–law equation.

To promote osteointegration, bioactive cuttlebone particles containing collagen were used to fill an acrylic cement, varying filler concentration (0-50 wt%). Cuttlebone was characterized by X-ray diffraction, plasma atomic emission and FT-IR. Mechanical properties of the filled cement were determined following ASTM procedures, included stress-strain, compression, bending, and fracture toughness tests. For in vivo tests, three groups of seven adult healthy rabbits were prepared to make an implant in the parietal bone of each one. For such groups (I-III), the amount of filler in the cement was 0, 10 and 30 wt%, respectively. Mechanical results for the composites complied with norm requirements. However, as mechanical performance for composite with 50 wt% of filler decreased significantly, for the in vivo tests, such composite was excluded. In vivo tests showed that three implants of group I were loosely attached to the parietal bone, whereas all the implants made with cement containing cuttlebone particles (groups II and III) were firmly attached to the parietal bone, indicating osteointegration. These results clearly show the potential of this type of bioactive filler to be used for medical applications.