Over the present material synthesis routes, the sonochemical route is highly efficient and comfortable way to produce nanostructured materials. In this way, the copper sulfide (CuS-covellite) and sulfur doped reduced graphene oxide (S-rGO) nanocomposite was prepared by sonochemical method. Interestingly, the structure of the as-prepared S-rGO/CuS was changed from the covellite to digenite phase. Herein, the S-rGO was act as a mild oxidizer and liable for the structural transformations. These structural changes are sequentially studied by various physicochemical characterizations such as Fourier transform infrared spectroscopy (FT-IR), Raman spectroscopy, X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and Transmission electron microscopy (TEM). After scrupulous structural evaluations, the transformation of CuS phase was identified and documented. This oxidized CuS has an excellent electrocatalytic activity when compare to the bulk CuS. This S-rGO/CuS was further used for the determination of glucose and acquired good electrocatalytic performances. This S-rGO/CuS was exhibited a wide linear concentration range, 0.0001–3.88 mM and 3.88–20.17 mM, and a low-level detection limit of 32 nM. Moreover, we have validated the practicability of our developed glucose sensor in real biological samples.

No abstract

Followed by decades of successful efforts in developing cathode materials for high specific capacity lithium-ion batteries, currently the attention is on developing a high-voltage battery (>5 V vs Li/Li+) with an aim to increase the energy density for their many fold advantages over conventional <4 V batteries. Among the various cathode materials, phosphate polyanion materials (LiMPO4, where M is a single metal or a combination of metals) showed promising candidacy given their high electrochemical potential (4.8–5 V vs Li/Li+), long cycle stability, low cost, and achieved specific capacity (∼165 mAh·g–1) near to its theoretical limit (170 mAh·g–1). In this review, factors affecting the electrochemical potential of the cathode materials are reviewed and discussed. Techniques to improve the electrical and ionic conductivities of phosphate polyanion cathodes, namely, surface coating, particle size reduction, doping, and morphology engineering, are also discussed. A processing–property correlation in phosphate polyanion materials is also undertaken to understand relative merits and drawbacks of diverse processing techniques to deliver a material with targeted functionality. Strategies required for high-voltage phosphate polyanion cathode materials are envisioned, which are expected to deliver lithium-ion battery cathodes with higher working potential and gravimetric specific capacity.

In this present work, "killing two birds with one stone" strategy was performed for the electrochemical trace level detection and photocatalytic degradation of antibiotic drug chloramphenicol (CAP) using Ce(MoO) nanocubes/graphene oxide (CeM/GO) composite for the first time. The CeM/GO composite was synthesized via simple hydrothermal treatment followed by sonication process. The successful formation of CeM/GO composite was confirmed by several analytical and spectroscopic techniques. The CeM/GO composite modified glassy carbon electrode (GCE) showed excellent electrocatalytic activity toward the reduction of CAP in terms of decrease the potential and increase the cathodic peak current in comparison with different modified and unmodified electrodes. The electrocatalytic reduction of CAP based on the CeM/GO modified GCE exhibited high selectivity, wide linear ranges, lower detection limit, and good sensitivity of 0.012-20 and 26-272 μM, 2 nM ,and 1.8085 μA μM cm, respectively. Besides, when CeM/GO/GCE was used to analyze the CAP in real samples, such as honey and milk, the satisfactory recovery results were obtained. On the other hand, the CeM/GO composite played excellent catalyst toward the photodegradation of CAP. The obtained results from the UV-vis spectroscopy clearly suggested that CeM/GO composite had high photocatalytic activity compared to pristine Ce(MoO4) nanocubes. The degradation efficiency of CeM/GO toward CAP is observed about 99% within 50 min under visible irradiation and it shows a good stability by observing the reusability of the catalyst. The enhanced photocatalytic performance was attributed to the increased migration efficiency of photoinduced electrons and holes.