No abstract

A compact silicon polarization beam splitter (PBS) is proposed based on an asymmetrical directional coupler consisting of a wide waveguide and a dielectric loaded narrow waveguide. Given that TE and TM polarizations are the dominant mode in the wide and narrow waveguides, respectively, a perfect phase-matching condition in the TM mode but a huge phase mismatching in the TE mode can be achieved. Therefore, the TE mode is almost uncoupled regardless of device length but the TM mode can only completely couple to the cross port at an appropriate coupling length. An ultrashort (∼8.13  μm long) PBS is designed based on a silicon-on-insulator nanowire with a loading refractive index of 2.0 and a gap width of 200 nm. Numerical simulations show that the proposed PBS has a broad bandwidth (∼100  nm) with large extinction ratio (>10  dB) and low insertion loss (<0.61  dB). The fabrication-error tolerance of the PBS is also discussed.

A compact polarization rotator (PR) with an asymmetric single dielectric loaded rib waveguide is proposed. The core of the waveguide is designed to have a specific rectangular configuration. The waveguide requires only a single asymmetrical dielectric loading on the core to complete the polarization conversion. The optical field is confined to the vicinity of the core center, which matches the optical field of the input/output waveguides. The transition loss of the PR is as low as 0.03-0.21 dB/facet without the taper or offset schemes. Such results can facilitate the fabrication of a PR with an operating length of 10 μm. In a comprehensively designed PR with a length of 7.92 μm, a -1  dB bandwidth for polarization conversion efficiency (PCE) is greater than 100 nm at the communicating wavelength of 1550 nm. The loading width and thickness with ±20  nm tolerance exhibit -0.87 and -0.49  dB changes in PCE, respectively.

We introduce a type of LED light-gauge steel frame lamp with an adjustable illumination light field that does not require a diffusion plate. Base on the Monte Carlo ray tracing method, this lamp has a good glare rating (GR) of 17.5 at 3050 lm. Compared with the traditional LED light-gauge steel frame lamp (without diffusion plate), the new type has low GR. The adjustability of the illumination light field could improve the zebra effect caused by the inadequate illumination light field of the lamp. Meanwhile, we adopt the retinal image analysis to discuss the influence of GR on vision. High GR could reflect stray light on the retinal image, which will reduce vision clarity and hasten the feeling of eye fatigue.

Optical waveguides based on benzocyclobutene polymer are fabricated by electron‐beam direct writing without etching. The propagation losses of waveguide measured at 1.55 μm for both TE and TM polarizations are 0.76 and 0.86 dB/cm, respectively. Moreover, the characteristics of waveguide bends are discussed for comparison. © 2004 Wiley Periodicals, Inc. Microwave Opt Technol Lett 42: 208–210, 2004; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.20254