Charge-states modulation of nitrogen-vacancy (NV) centers incorporated into single crystal diamond films attracts increasing attention for solid-state qubits applications. Here, we discuss the electro- and photoluminescence emission properties of NV centers incorporated by gas phase nitrogen delta-doping of the intrinsic diamond layer of a positive-intrinsic-negative (PIN) junction diode. The experiments show that the charge state of NV centers can be intentionally controlled by applying well-defined external bias voltages. It can be switched from the negatively charged state NV (-) to the neutral charged state NV(0) when a strong forward bias potential is applied. This can be switched back by application of reverse potentials. These results will be discussed assuming basic electronic properties of diamond PIN diodes, including the variation of spectral properties as well as the dynamics of charge state transitions

In this paper, we demonstrate an active control of the charge state of a single nitrogen-vacancy (NV) centre by using in-plane Schottky-diode geometries with aluminium on hydrogen-terminated diamond surface. A switching between NV+, NV0 and NV− can be performed with the Al-gates which apply electric fields in the hole depletion region of the Schottky junction that induces a band bending modulation, thereby shifting the Fermi-level over NV charge transition levels. We simulated the in-plane band structure of the Schottky junction with the Software ATLAS by solving the drift-diffusion model and the Poisson-equation self-consistently. We simulated the IV-characteristics, calculated the width of the hole depletion region, the position of the Fermi-level intersection with the NV charge transition levels for different reverse bias voltages applied on the Al-gate. We can show that the field-induced band bending modulation in the depletion region causes a shifting of the Fermi-level over NV charge transition levels in such a way that the charge state of a single NV centre and thus its electrical and optical properties is tuned. In addition, the NV centre should be approx. 1–2 μm away from the Al-edge in order to be switched with moderate bias voltages.

The negatively charged nitrogen-vacancy (NV) centre exhibits outstanding optical and spin properties and thus is very attractive for applications in quantum optics. Up to now an active control of the charge state of near-surface NV centres is difficult and the centres switch in an uncontrolled way between different charge states. In this work, we demonstrate an active control of the charge state of NV centres (implanted 7 nm below the surface) by using an in-plane Schottky diode geometry from aluminium on hydrogen terminated diamond in combination with confocal micro-photoluminescence measurements. The partial quenching of NV-photoluminescence caused by the hole accumulation layer of the hydrogen terminated surface can be recovered by applying reverse bias potentials on this diode, i.e. the NV0 charge state is depleted while the NV− charge state is populated. This charge state conversion is caused by the bias voltage affected modulation of the band bending in the depletion region which shifts the Fermi level across the NV charge transition levels.

The nitrogen-vacancy (NV) center in diamond is a promising quantum system for magnetometry applications exhibiting optical readout of minute energy shifts in its spin sub-levels. Key material requirements for NV ensembles are a high NV- concentration, a long spin coherence time and a stable charge state. However, these are interdependent and can be difficult to optimize during diamond growth and subsequent NV creation. In this work, we systematically investigate the NV center formation and properties in bulk chemical vapor deposition (CVD) diamond. The nitrogen flow during growth is varied by over 4 orders of magnitude, resulting in a broad range of single substitutional nitrogen concentrations of 0.2-20~parts per million. For a fixed nitrogen concentration, we optimize electron-irradiation fluences with two different accelerated electron energies, and we study defect formation via optical characterizations. We discuss a general approach to determine the optimal irradiation conditions, for which an enhanced NV concentration and an optimum of NV charge states can both be satisfied. We achieve spin-spin coherence times T2 ranging from 45.5 to 549 μs for CVD diamonds containing 168 to 1~parts per billion NV- centers, respectively. This study shows a pathway to engineer properties of NV-doped CVD diamonds for improved sensitivity.

In this paper, we demonstrate an active and fast control of the charge state and hence of the optical and electronic properties of single and near-surface nitrogen-vacancy centres (NV centres) in diamond. This active manipulation is achieved by using a two-dimensional Schottky-diode structure from diamond, i.e., by using aluminium as Schottky contact on a hydrogen terminated diamond surface. By changing the applied potential on the Schottky contact, we are able to actively switch single NV centres between all three charge states NV+, NV0 and NV− on a timescale of 10 to 100 ns, corresponding to a switching frequency of 10–100 MHz. This switching frequency is much higher than the hyperfine interaction frequency between an electron spin (of NV−) and a nuclear spin (of 15N or 13C for example) of 2.66 kHz. This high-frequency charge state switching with a planar diode structure would open the door for many quantum optical applications such as a quantum computer with single NVs for quantum information processing as well as single 13C atoms for long-lifetime storage of quantum information. Furthermore, a control of spectral emission properties of single NVs as a single photon emitters – embedded in photonic structures for example – can be realized which would be vital for quantum communication and cryptography.