We have solved numerically the diffusive Usadel equations that describe the spatially-varying superconducting proximity effect in Ti − Al thin-film bi-and trilayers with thickness values that are suitable for Kinetic Inductance Detectors (KIDs) to operate as photon detectors with detection thresholds in the frequency range of 50−90 GHz. Using Nam's extension of the Mattis-Bardeen calculation of the superconductor complex conductivity, we show how to calculate the surface impedance for the spatially varying case, and hence the surface impedance quality factor. In addition, we calculate energy-and spatially-averaged quasiparticle lifetimes at temperatures well-below the transition temperature and compare to calculation in Al. Our results for the pair-breaking threshold demonstrate differences between bilayers and trilayers with the same total film thicknesses. We also predict high quality factors and long multilayer-averaged quasiparticle recombination times compared to thinfilm Al. Our calculations give a route for designing KIDs to operate in this scientifically-important frequency regime.

We have developed a coupled-mode analysis framework for superconducting travelling-wave parametric amplifiers using the full Telegrapher's equations to incorporate loss-related behaviour. Our model provides an explanation of previous experimental observations regarding loss in amplifiers, advantages of concatenating amplifiers to achieve high gains, and signal gain saturation. This work can be used to guide the design of amplifiers in terms of the choice of material systems, transmission line geometry, operating conditions, and pump strength.

We consider the effects of quasiparticle heating on the dynamical behaviour of superconducting microresonators operating with high readout powers. It is seen that resonance-curve distortion and hysteretic switching are an inevitable consequence of the forms of the quasiparticle heating and cooling functions. The model uses a diagrammatic representation of dynamical behaviour to gain an insight into how the instantaneous operating point moves in response to step changes in readout power, signal power, bath temperature, and frequency. The coupling quality factor has a marked effect on non-linear behaviour. The model is used to calculate the waveforms generated when a device switches between hysteretic states. The work suggests that measured response times need not be representative of intrinsic quasiparticle relaxation rates.

Abstract. An electrothermal model of Kinetic Inductance Detectors (KIDs) is described. The non-equilibrium state of the resonator's quasiparticle system is characterized by an effective temperature, which because of readout-power heating is higher than that of the bath. By balancing the flow of energy into the quasiparticle system, it is possible to calculate the steady-state large-signal, small-signal and noise behaviour. Resonance-curve distortion and hysteretic switching appear naturally within the framework. It is shown that an electrothermal feedback process exists, which affects all aspects of behaviour. It is also shown that generation-recombination noise can be interpreted in terms of the thermal fluctuation noise in the effective thermal conductance that links the quasiparticle and phonon systems of the resonator. Because the scheme is based on electrothermal considerations, multiple elements can be added to simulate the behaviour of complex devices, such as resonators on membranes, again taking into account readout power heating.

We discuss how reactive and dissipative nonlinearities affect the intrinsic response of superconducting thin-film resonators. We explain how most, if not all, of the complex phenomena commonly seen can be described by a model in which the underlying resonance is a single-pole Lorentzian, but whose centre frequency and quality factor change as external parameters, such as readout power and frequency, are varied. What is seen during a vector-network-analyser measurement is series of samples taken from an ideal Lorentzian that is shifting and spreading as the readout frequency is changed. According to this model, it is perfectly proper to refer to, and measure, the resonant frequency and quality factor of the underlying resonance, even though the swept-frequency curves appear highly distorted and hysteretic. In those cases where the resonance curve is highly distorted, the specific shape of the trajectory in the Argand plane gives valuable insights into the second-order physical processes present. We discuss the formulation and consequences of this approach in the case of nonlinear kinetic inductance, two-level-system loss, quasiparticle generation, and a generic model based on a power-law form. The generic model captures the key features of specific dissipative nonlinearities, but additionally leads to insights into how general dissipative processes create characteristic forms in the Argand plane. We provide detailed formulations in each case, and indicate how they lead to the wide variety of phenomena commonly seen in experimental data. We also explain how the properties of the underlying resonance can be extracted from this data. Overall, our paper provides a self-contained compendium of behaviour that will help practitioners interpret and determine important parameters from distorted swept-frequency measurements.