Modification of poplar (Populus adenopoda Maxim) wood by using maltodextrin (MA) combined with 1,3-dimethylol-4,5-dihydroxyethyleneurea (DM) resin was investigated in this study. The weight percent gain, dimensional stability, mechanical strength, and microscopic chemical change were determined before and after impregnation. Results indicated that the composite modifier was impregnated into the wood cell lumen, as verified by scanning electron microscopy and a change in weight percent gain. Anti-swelling efficiency was significantly improved compared with the untreated sample; however, the sample treated with MA obtained an anti-swelling efficiency that was slightly lower than that of the sample treated with sucrose. The flexural strength, flexural modulus, and compressive strength perpendicular to the grain increased with an increase in MA concentration, but the compressive modulus and impact strength were reduced. Fourier-transform infrared spectroscopy demonstrated that MA delayed the cross-linking of the DM resin cell wall, and X-ray diffraction analysis showed that the crystallinity of the cellulose crystalline region was reduced to a certain extent. In general, the poplar wood treated with combined MA and DM resin exhibited enhanced properties relative to those of the poplar wood treated with sucrose.

In order to explore the emission characteristics of volatile organic compounds (VOCs) and different VOC components in airtight environments, polyvinyl chloride laminated plywood (PVC-P), melamine-impregnated paper laminated plywood (MI-P), water-based paint laminated plywood (WP-P) and unfinished plywood (UF-P) were tested as materials in 15 L small environment cabins. VOCs were collected after being sealed for 2 h, 4 h, 6 h, 8 h, 12 h, 18 h, 24 h and 30 h under different loading ratios (1 m2/m3, 1.5 m2/m3, 2 m2/m3, 2.5 m2/m3) and analyzed using a gas chromatography–mass spectrometer. The results show that VOCs gradually increased and tended to be saturated with the increase of time in an airtight environment. The saturation of veneered plywood was faster than unfinished plywood and the pollution degree of three kinds of veneered plywood from lowest to highest was in order of PVC-P, MI-P, WP-P. Aromatic hydrocarbons account for more than half of VOC concentration, and was most obviously affected by the loading ratios. Surfaced laminated plywood can reduce the emission of aromatic hydrocarbons, but also increases the amount of other compounds released. The concentration of VOC-components shows different characteristic curves at different loading ratios due to the influence of decorative materials.

No abstract

The pretreatment of Mongolian pine (Pinus sylvestris var. mongholica Litv.) was conducted with saturated wet air (80 °C) and atmospheric saturated steam (100 °C) before high-frequency vacuum drying. Effects of the pretreatment on moisture content (MC), drying rate, drying crack, and drying shrinkage strain were investigated. The results showed that through pretreatment, the initial MC of the test material decreased by 2.6% to 6%, and the MC distribution was uniform. The maximum difference of the untreated wood MC distribution after drying was 2%, while that within the pretreated wood was less than 1%. The drying rate also increased, as the drying rates of the untreated and pretreated wood were 0.268%/h, 0.333%/h, and 0.398%/h, respectively. The drying shrinkage strain of the sample was reduced. The drying shrinkage strain of untreated wood was between 0.044 and 0.063, while the drying shrinkage strain of pretreatment wood was between 0.013 and 0.049. The crack of the test material was also reduced, and the drying quality was improved. The pretreatment reduced the high-frequency vacuum drying stress of wood and improved the drying speed and quality.