Pork loins (n = 72) were selected so that marbling scores would range from "practically devoid" to "abundant" in the longissimus muscle. Loin chops were cooked and rated by a trained six-member sensory panel. Physical and chemical characteristics were stratified according to marbling level (divided into 10 subclasses), muscle structure, shear force, overall palatability, and juiciness (each divided into three subclasses). The highest ratings for overall palatability were assigned to chops with high reflectance (685 nm), low moisture (70.1%), high i.m. fat (9.1%; or, high marbling score), low protein (19.4%), and low cooking loss (25.9%). Chops with the highest percentage of cooking loss were high in moisture content (75.59%), low in i.m. fat (1.78%), and high in protein content (21.54%). Differences in muscle structure, shear force, overall palatability, and juiciness were associated with differences in percentages of protein, moisture (whole tissue basis [WTB]) and fat (WTB). Pork loins with marbling between "practically devoid-plus" and "small" had (P less than .05) more protein and less fat (WTB) than loins with marbling scores between "modest" and "abundant." Loins with overall palatability ratings between 4.0 and 6.0 had more moisture and protein (P less than .05) than did loins with palatability ratings of 6.1 to 8.0. Selecting pork loins with "small" or less marbling, extremely open structure, a juicy rating of "slightly juicy," and an overall palatability rating of "like slightly" would identify fresh loins that had lower fat and(or) higher protein content.

The effect of diethylstilbestrol (DES) on the composition of tissue gain of Hereford steers was studied in a complete slaughter balance trial. Eight steers were slaughtered initially (IS) and, after 177 days on feed, eight control steers (C) and seven steers that had been fed 20 mg DES daily (DES) were slaughtered. Initial full body weight averaged 224.8 kg, and final full body weight averaged 403.0 kg for the C steers and 433.6 kg for the DES steers. Final empty body weight averaged 346.6 kg for the C steers and 368.0 kg for the DES steers. DES improved live weight gain by 17% and conversion of feed dry matter to live weight by 12%. Recovery of wet weight during slaughter averaged 99.6%. DES steers had larger rib cut weights and greater proportions of separable lean and bone plus connective tissue in the rib cuts than C steers, an ribeye area tended to be larger in DES steers. DES caused a small shift in relative body composition toward more protein, moisture and ash. Tissue gain in DES steers consisted of 28.3% more protein, 26.0% more moisture, 73.2% more ash, 1.5% less fat and 109.1% more residual (dry matter not accounted for by N x 6.25, ether extract and ash) than did tissue gain in C steers. Energy gain per unit of energy intake over the feeding period was not affected by DES treatment, but DES improved protein gain per unit of protein intake and per unit of energy intake by approximately 20% within the total empty body and by about 25% within the carcass fraction. Results confirm indirect estimates in the literature indicating that DES increases skeletal growth and lean tissue deposition in feedlot steers.

In this short-term study, comparably lean beef and chicken had similar effects on plasma levels of total, low-density lipoprotein, and high-density lipoprotein cholesterol and triglyceride. We concluded that lean beef and chicken are interchangeable in the Step I Diet.

Data from 68 cow carcasses were used to develop a new yield grading system. First principal component (FPC) values for compositional attributes (LNFT = separable lean weight/[lean+fat weight] x 100, LNBN = separable lean weight/[lean+bone+connective tissue weights] x 100, and BTPR = [defatted lean from the round, loin, rib, and chuck]/side weight x 100) were determined. The first component explained 83.5% of the standardized variance and load values were .63, -.52, and .58, respectively. The resulting FPC values ranged from -1.93 to 1.89. The linear regression of LNFT, LNBN, and BTPR (dependent variables) on FPC (independent variable) explained a significant amount of variation (P less than .001) in each case and resulted in R2-values of .98, .67, and .85, respectively. A best-fit yield grade equation, developed to predict FPC, included adjusted fat thickness (ADF), percentage of kidney, pelvic, and heart fat (KPH), and overall muscling grade (OM). The equation, FPC = 2.04 - (.67 x ADF) - (.21 x KPH) - (.0016 x OM), explained a significant amount (P less than .001) of variation in FPC with R2 = .94 and residual standard deviation = .25. Simple correlations for ADF, KPH, and OM with FPC were -.87, -.71, and -.80, respectively. Cow carcasses were assigned to one of three grades based on FPC values that corresponded with predetermined levels of LNFT, LNBN, and BTPR. These grades generally had smaller CV than existing grades. When used in conjunction with quality grades, proposed grades could be more useful to the cow meat industry.

No abstract