No abstract

No abstract

No abstract

A note on versions:The version presented here may differ from the published version or from the version of record. If you wish to cite this item you are advised to consult the publisher's version. Please see the repository url above for details on accessing the published version and note that access may require a subscription. Highlights The influence of mineralogy on microwave-induced fracture in ores is investigated  Microwave-heating phase and matrix thermo-mechanical properties are both important  Hard microwave-heating phases constrained by a hard matrix gave the best results  ~2-20%wt heating phase abundance with grain size d50 >500µm gave the best results  Ore textural consistency is required for high average strength reductions AbstractHigh power density microwave treatments on metalliferous ores have historically been shown to reduce ore competency prior to beneficiation at economically feasible energy inputs. However, the relationship between mineralogical textural features and the extent of the microwave-induced fracturing had previously been limited to qualitative descriptions or simplistic two-phase numerical models, which could not account for the complex mineral assemblages in real ores. In this paper, mineralogy, grain size, dissemination, textural consistency and mineral associations were determined for 13 commercially exploited nickel, copper and lead-zinc ores using a Mineral Liberation Analyser (MLA). The ores were subjected to high power density microwave treatments at up to 25kW in a single mode cavity with microwave energy inputs of approximately 0.5-10kWh/t, and the subsequent reductions in ore competency were measured by the Point Load Test. The ores that demonstrated the greatest reductions in strength typically contained between approximately 2%wt to 20%wt of highly microwave-absorbing minerals, with a native grain size d50 greater than approximately 500µm, constrained by hard matrix minerals such as quartz and feldspar. Texturally consistent ores with a high proportion of amenable textures also demonstrated the highest average reductions in strength. These findings support the qualitative descriptions and numerical modelling results available in the literature and provide a baseline for selecting likely candidate ores for microwave treatments in the future. Minerals Engineering 84 (2015) 116-1292 http://dx

No abstract