We report a high-sensitivity, disposable lab-on-a-chip with a thin-film organic light-emitting diode (OLED) excitation source and an organic photodiode (OPD) detector for on-chip fluorescence analysis. A NPB/Alq3 thin-film green OLED with an active area of 0.1 cm(2) was used as the excitation source, while a CuPC/C(60) thin-film OPD with 0.6 cm(2) active area was used as a photodetector. A novel cost-effective, cross-polarization scheme was used to filter out excitation light from a fluorescent dye emission spectrum. The excitation light from the OLED was linearly polarized and used to illuminate a microfluidic device containing a 1 microL volume of dye dissolved in ethanol. The detector was shielded by a second polarizer, oriented orthogonally to the excitation light, thus reducing the photocurrent due to excitation light leakage on the detector by approximately 25 dB. The fluorescence emission light, which is randomly polarized, is only attenuated by approximately 3 dB. Fluorescence signals from Rhodamine 6G (peak emission wavelength of 570 nm) and fluorescein (peak emission wavelength of 494 nm) dyes were measured in a dilution series in the microfluidic device with emission signals detected by the OPD. A limit-of-detection of 100 nM was demonstrated for Rhodamine 6G, and 10 microM for fluorescein. This suggests that an integrated microfluidic device, with an organic photodiode and LED excitation source and integrated polarizers, can be fabricated to realize a compact and economical lab-on-a-chip for point-of-care fluorescence assays.

Thin solid films of salmon deoxyribonucleic acid (DNA) have been fabricated by treatment with a surfactant and used as host for the laser dye sulforhodamine (SRh). The DNA films have an absorption peak at approximately 260 nm owing to absorption by the nitrogenous aromatic bases. The SRh molecules in the DNA films have absorption and emission peaks at 578 and 602 nm, respectively. The maximum emission was obtained at approximately 1 wt. % SRh in DNA, equivalent to approximately 100 DNA base pairs per SRh molecule. A distributed feedback grating structure was fabricated on a SiO(2)-Si substrate using interference lithography. The grating period of 437 nm was selected, corresponding to second-order emission at the amplified spontaneous emission wavelength of 650 nm. Lasing was obtained by pumping with a doubled Nd:YAG laser at 532 nm. The lasing threshold was 3 microJ, corresponding to approximately 30 microJ/cm(2) or 4 kW/cm(2). The emission linewidth decreased from approximately 30 nm in the amplified spontaneous emission mode to <0.4 nm (instrument limited) in the lasing mode. The slope efficiency of the lasing was approximately 1.2%.

No abstract

No abstract