In this first part of a two-part paper, the results of measurement of static pressure distribution on the tibial surface of the knee are presented. Results with intact menisci have been obtained from 18 specimens. Eight of these specimens were the subject of further measurements following medial meniscectomy. The study has been carried out at various flexion angles of the knee with the joint subjected to a compressive force, with or without an initial passive relative displacement between the joint members. The results indicate that a significant fraction of the joint compressive load is transmitted through the menisci and that total meniscectomy causes a drastic alteration in the pressure distribution on the tibial surface. Clinical implications of these results, in terms of post-meniscectomy degenerative changes and mechanism of meniscal lesions, have been discussed.

We evaluated the initial stability of cemented and uncemented femoral components within the femoral canals of cadaver femurs during simulated single limb stance and stair climbing. Both types were very stable in simulated single limb stance (maximum micromotion of 42 microns for cemented and 30 microns for uncemented components). However, in simulated stair climbing, the cemented components were much more stable than the uncemented components (76 microns as against 280 microns). There was also greater variation in the stability of uncemented components in simulated stair climbing, with two of the seven components moving 200 microns or more. Future implant designs should aim to improve the initial stability of cementless femoral components under torsional loads; this should improve the chances of bony ingrowth.

Tensions generated in selected bands of the four major ligaments of the flexed knee (40-90 degrees) have been measured in vitro when the tibia is subjected to passive anterior translation and axial rotation with and without a compressive preload. The measurements were made in 30 fresh-frozen specimens using the buckle transducer attached to the anteromedial band of the anterior cruciate ligament [ACL (am)], the posterior fibres of the posterior cruciate ligament [PCL (pf)], the superficial fibres of the medial collateral ligament [MCL (sf)], and in the total lateral collateral ligament (LCL). Particular attention was placed on the evaluation of the performance of the transducer specific to such measurements in order to minimize the errors associated with the use of this transducer. The results indicate that, among the measured ligaments, substantial tension (greater than 20 N) is generated only in the ACL (am) in tibial anterior translation up to 5 mm. The tension pattern generated in response to tibial axial rotation, however, is complex and exhibits considerable variation between specimens. In general, both the MCL (sf) and LCL are tensed at all tested flexion angles, with the tension in external rotation being significantly greater than in internal rotation. At 40 degrees of flexion, the ACL (am) bears tension mainly in internal rotation, while at 90 degrees of flexion the PCL (pf) is tensed in both senses of rotation. The response of the LCL shows marked variation among specimens; very small tension (less than 15 N) is generated in internal rotation in 48% of the specimens, and in either sense of rotation in 20% of the specimens. The tension in the ACL (am) in internal rotation is invariably greater in those specimens in which LCL tension is negligible. This correlation between increased ACL (am) function and inadequate LCL restraint appears significant in terms of ACL injury and repair.

The in-vitro static load-displacement properties of the intact and the injured human lumbar intervertebral joint have been investigated in a loading apparatus which allows entirely unconstrained relative displacement between the joint members. The spatial relative displacement produced by a given load, alone or in combination with another load (preload), were measured using 14 specimens and emphasizing strict control of the secondary variables which are known to affect the results. An attempt has been made to interpret the results in terms of the relative load-bearing roles of the disk, the facets and the posterior ligaments as a function of the type of load. The results indicate that the disk is the major load-bearing element in lateral and anterior (with respect to fixed superior vertebra) shears, axial compression and flexion, while the facets play a major role in posterior shear and axial torque.