Several magnetic properties have recently become tunable with an applied electric field. Particularly, electrically controlled magnetic phase transitions and/or magnetic moments have attracted attention because they are the most fundamental parameters in ferromagnetic materials. In this study, we showed that an electric field can be used to control the magnetic moment in films made of Pd, usually a non-magnetic element. Pd ultra-thin films were deposited on ferromagnetic Pt/Co layers. In the Pd layer, a ferromagnetically ordered magnetic moment was induced by the ferromagnetic proximity effect. By applying an electric field to the ferromagnetic surface of this Pd layer, a clear change was observed in the magnetic moment, which was measured directly using a superconducting quantum interference device magnetometer. The results indicate that magnetic moments extrinsically induced in non-magnetic elements by the proximity effect, as well as an intrinsically induced magnetic moments in ferromagnetic elements, as reported previously, are electrically tunable. The results of this study suggest a new avenue for answering the fundamental question of “can an electric field make naturally non-magnetic materials ferromagnetic?”

We investigate the applicability of measuring surface tension of liquid microdroplets by analyzing their oscillatory behavior induced by droplet collision. The eigenfrequency of droplet oscillation reflects surface tension for small-amplitude oscillation. In this study, the oscillation frequencies of ethanol–ethanol and water–water droplet collisions are measured by direct observation. We experimentally verify that surface tension can be measured for deformation smaller than 10% of the droplet radius. The collision between ethanol–water droplets is also analyzed. The eigenfrequency induced by unlike-droplet collision exhibits a peculiar behavior, which may be attributed to the temporal hybrid structure of a combined droplet.

Self-assembly is one of the most promising strategies for making functional materials at the nanoscale, yet new design principles for making self-limiting architectures, rather than spatially unlimited periodic lattice structures, are needed. To address this challenge, we explore the tradeoffs between addressable assembly and self-closing assembly of a specific class of self-limiting structures: cylindrical tubules. We make triangular subunits using DNA origami that have specific, valence-limited interactions and designed binding angles, and we study their assembly into tubules that have a self-limited width that is much larger than the size of an individual subunit. In the simplest case, the tubules are assembled from a single component by geometrically programming the dihedral angles between neighboring subunits. We show that the tubules can reach many micrometers in length and that their average width can be prescribed through the dihedral angles. We find that there is a distribution in the width and the chirality of the tubules, which we rationalize by developing a model that considers the finite bending rigidity of the assembled structure as well as the mechanism of self-closure. Finally, we demonstrate that the distributions of tubules can be further sculpted by increasing the number of subunit species, thereby increasing the assembly complexity, and demonstrate that using two subunit species successfully reduces the number of available end states by half. These results help to shed light on the roles of assembly complexity and geometry in self-limited assembly and could be extended to other self-limiting architectures, such as shells, toroids, or triply periodic frameworks.

The ability to design and synthesize ever more complicated colloidal particles opens the possibility of self-assembling a zoo of complex structures, including those with one or more self-limited length scales. An undesirable feature of systems with self-limited length scales is that thermal fluctuations can lead to the assembly of nearby, off-target states. We investigate strategies for limiting off-target assembly by using multiple types of subunits. Using simulations and energetics calculations, we explore this concept by considering the assembly of tubules built from triangular subunits that bind edge to edge. While in principle, a single type of triangle can assemble into tubules with a monodisperse width distribution, in practice, the finite bending rigidity of the binding sites leads to the formation of off-target structures. To increase the assembly specificity, we introduce tiling rules for assembling tubules from multiple species of triangles. We show that the selectivity of the target structure can be dramatically improved by using multiple species of subunits, and provide a prescription for choosing the minimum number of subunit species required for near-perfect yield. Our approach of increasing the system’s complexity to reduce the accessibility of neighboring structures should be generalizable to other systems beyond the self-assembly of tubules.