Nanoparticle Tracking Analysis (NTA) has been employed to measure the particle concentration and size distribution of magnetosomes extracted and purified from Magnetospirillum gryphiswaldense MSR-1, and then exposed to probe ultrasonication for various times, or 1% (w/v) sodium dodecyl sulphate (SDS) for 1 h. Particle concentration increased 3.7-fold over the first 15 min of ultrasonication (from 2 × 10 8 to >7.3 × 10 8 particles mL -1 ), but fell steeply to ~3.6 × 10 8 particles mL -1 after 20 min. NTA of untreated magnetosome preparation confirmed a wide particle distribution dominated by larger species (D[1,0] = 312 nm; Dn50 = 261 nm; mode = 243 nm) with no particles in the size range of isolated single magnetosomes. After 5 min of ultrasonication the whole particle size distribution shifted to smaller size (D[1,0] = 133 nm; Dn50 = 99 nm; mode = 36 nm, corresponding to individual magnetosomes), but longer treatment times (15 and 20 min) reversed the previous transition; all characteristic numbers of the particle size distributions increased and very few small particles were detected. Side-by-side comparison of NTA and TEM sizing data revealed remarkable similarity at low ultrasonication times, with both showing single magnetosomes accounted for ~30% population after 5 min. Exposure of magnetosomes to SDS resulted in a ~3-fold increase in particle concentration to 5.8 × 10 8 particles mL -1 , narrowing of the size distribution and gross elimination of particles below 60 nm. We conclude that NTA is a rapid cost-effective technique for measuring particle number, size distribution and aggregation state of magnetosomes in solution, but requires further work to improve its resolving power.

To fabricate nanofibers with reproducible characteristics, an important demand for many applications, the effect of controlled atmospheric conditions on resulting electrospun cellulose acetate (CA) nanofibers was evaluated for temperature ranging 17.5-35°C and relative humidity ranging 20%-70%. With the potential application of nanofibers in many industries, especially membrane and filter fabrication, their reproducible production must be established to ensure commercially viability. Cellulose acetate (CA) solution (0.2 g/ml) in a solvent mixture of acetone/DMF/ethanol (2:2:1) was electrospun into nonwoven fibre mesh with the fibre diameter ranging from 150nm to 1µm. The resulting nanofibers were observed and analyzed by scanning electron microscopy (SEM), showing a correlation of reducing average fibre diameter with increasing atmospheric temperature. A less pronounced correlation was seen with changes in relative humidity regarding fibre diameter, though it was shown that increased humidity reduced the effect of fibre beading yielding a more consistent, and therefore better quality of fibre fabrication. Differential scanning calorimetry (DSC) studies observed lower melt enthalpies for finer CA nanofibers in the first heating cycle confirming the results gained from SEM analysis. From the conditions that were explored in this study the temperature and humidity that gave the most suitable fibre mats for a membrane purpose were 25.0°C and 50%RH due to the highest level of fibre diameter uniformity, the lowest level of beading while maintaining a low fibre diameter for increased surface area and increased pore size homogeneity. This study has highlighted the requirement to control the atmospheric conditions during the electrospinning process in order to fabricate reproducible fibre mats.

No abstract

No abstract