No abstract

No abstract

The purpose of this paper is to investigate the variation in the coefficient of friction (CoF) and also the wear in a lead bronze coating under different texture conditions. The tribological tests were performed using a tribometer with pin on disk configuration. Several kinds of textures, realised by a surface laser texturing, were tested by varying the diameter, depth, and density of the dimples under severe working conditions. The innovative aspect concerns the behaviour of the textured lead bronze coating and the lubrication conditions when the sample is subjected to extreme load conditions. Confocal microscopies and SEM (Scanning Electron Microscopy) / EDS (Energy Dispersive X-Ray Spectroscopy) analyses were performed to evaluate the texture behaviour and also the surface deterioration of the coating. The results show that the application of texture processing leads to an improvement in the tribological properties of the coating. By analysing separately the variation of the different geometric parameters of the dimples, it has been shown that the best results are obtained with a diameter of 50 μm, a density of 5%, and a depth of 5 μm.

No abstract

Titanium dental implants have had new competitors in recent years, such as fixtures made of zirconia, which promise better aesthetics. The purpose of this study is to evaluate their mechanical performance in silico (Finite Element Analysis). The investigation was performed on a single tooth Patent™ Dental Implant (Zircon Medical®, Altendorf, Switzerland) in two configurations: without offset (Test I) and with offset (Test II, 1.5 mm within the cortical bone). The Patent Implant system consists of two components: the implant with integrated abutment and the fibreglass post. The components of the dental implants were tested using a compression load of 400 N along the implant axis. The results showed that the chewing load generates stress distribution on the bone, therefore, the offset configuration should be avoided.