No abstract

No abstract

We demonstrate a fit‐for‐purpose accelerated durability test (ADT) of a high‐surface‐area catalyst for the alkaline oxygen evolution reaction (OER). Using an automatized electrochemical setup enabled us to run a complex ADT protocol including online detection of the effective solution resistance as well as linear voltammetry, cyclic voltammetry, cyclic galvanograms, and electrochemical impedance spectroscopy (EIS) for 55 h in total. Using this protocol, we tested the service life stability of a nickel oxyhydroxide (NiOx) catalyst based on Raney Ni. The catalyst was prepared by growing nickel oxyhydroxide on high‐surface‐area Raney Ni and subsequent formation of the active phase. The successful synthesis of the active NiOx phase is supported by cyclic voltammetry and Raman spectroscopy. The as prepared and activated Raney NiOx exhibits an overpotential for the OER of 304 mV at 10 mA cm−2 with a Tafel slope of 53 mV dec−1 and roughness factors as high as 4515 determined by EIS during OER. By concentrating for the ADT protocol on current densities relevant for coupling water electrolysis to photovoltaics, it is demonstrated that Raney NiOx is a promising anode material candidate as it is earth abundant and its active phase exhibits high OER activity as well as stability.

An efficient electrocatalyst comprising inexpensive and earth-abundant materials for the oxygen evolution reaction (OER) is crucial for the development of water electrolysis. In this work, in-situ addition of cobalt/molybdenum ions to the electrolytic manganese dioxide has been shown to be beneficial for the OER in acid solution as its overpotential performed better (305 mV) than that of the commercial DSA® (341 mV) at 100 mA cm−2. The OER was investigated at ambient temperature in 2 M H2SO4 solution on the modified EMD (MnMoCoO) electrodes. The energy efficiency of the MnMoCoO electrodes improved significantly with the amount of Co in the plating solution. For the electrodeposited catalysts, physico-chemical and electrochemical measurements were conducted including static overpotentials. The better performance of the modified EMD was attributed to an improved charge transfer resistance (Rct; 0.290 Ω cm2), average roughness factor (rf; 429) and decrease in water content in the electrodeposited catalysts. The kinetic parameters obtained on MnMoCoO catalysts were compared and discussed according to the cobalt concentration.

No abstract