The slipperiness of the surface is essential for road safety. The growing number of CCTV cameras opens the possibility of using them to automatically detect the slippery surface and inform road users about it. This paper presents a system of developed intelligent road signs, including a detector based on convolutional neural networks (CNNs) and the transfer-learning method employed to the processing of images acquired with video cameras. Based on photos taken in different light conditions by CCTV cameras located at the roadsides in Poland, four network topologies have been trained and tested: Resnet50 v2, Resnet152 v2, Vgg19, and Densenet201. The last-mentioned network has proved to give the best result with 98.34% accuracy of classification dry, wet, and snowy roads.

It is a common practise that measurements of road surface conditions are made using professional and expensive apparatus. Typically a van or a truck equipped with a set of professional sensors i.e. laser scanners of surface is used, therefore the measurement update period is often quite long. Two alternative low-cost methods for estimating road pavement defects and failures were proposed and investigated by the authors. The first one is based on accelerometers application and the other one employs image analysis acquired by cameras installed on a vehicle.

Two low-cost methods of estimating the road surface condition are presented in the paper, the first one based on the use of accelerometers and the other on the analysis of images acquired from cameras installed in a vehicle. In the first method, miniature positioning and accelerometer sensors are used for evaluation of the road surface roughness. The device designed for installation in vehicles is composed of a GPS receiver and a multi-axis accelerometer. The measurement data were collected from recorded ride sessions taken place on diversified road surface roughness conditions and at varied vehicle speeds on each of examined road sections. The data were gathered for various vehicle body types and afterwards successful attempts were made in constructing the road surface classification employing the created algorithm. In turn, in the video method, a set of algorithms processing images from a depth camera and RGB cameras were created. A representative sample of the material to be analysed was obtained and a neural network model for classification of road defects was trained. The research has shown high effectiveness of applying the digital image processing to rejection of images of undamaged surface, exceeding 80%. Average effectiveness of identification of road defects amounted to 70%. The paper presents the methods of collecting and processing the data related to surface damage as well as the results of analyses and conclusions.