A series of experiments were conducted using commercially available Al2O3:C optically stimulated luminescent dosimeters to provide a technical basis for their precise calibration and statistical performance at irradiated air kerma doses between 0.02 mGy and 5 mGy using 137Cs. This study examines the dose response linearity, studies the background signal for annealed dosimeters, and compares the statistical performance of dosimeters that were annealed and not annealed prior to their irradiation and readout. The average and standard deviation for the response of groups of dosimeters annealed and nonannealed prior to their irradiation were determined at each delivered dose. The batch of dosimeters that were annealed prior to their irradiation exhibited a coefficient of variation in its mean dose response below 10% when using three or more irradiation trials at each delivered air kerma dose between 0.02 mGy and 5 mGy. The reader calibration factor was calculated using the response of the annealed batch of dosimeters and was determined to be 756 ± 7 photomultiplier tube counts per mGy. Best estimates of the individual sensitivity factors were determined to be between 0.79 and 1.12 for the annealed batch of dosimeters. The minimum number of irradiations required to accurately determine the sensitivity factor of each individual dosimeter is reported with the recommended reader and dosimeter calibration procedures.

Experiments were performed with 30 11 cm × 42.5 cm × 5.5 cm NaI(Tl) detectors to better understand their positional response. Spectra were collected using 0.02 to 0.15 MBq point sources of 241Am, 137Cs, 60Co, and 133Ba positioned on lines parallel and perpendicular to the long axis of the crystal along both the narrow and wide detector faces as well as at different distances from them. A greater density of positions was sampled at the ends of the detector, and repeated measurements were made to examine potential gain drifts during the experiment. Spectroscopic peak counts, spectroscopic pulse heights, and net counts were analyzed. Empirical equations were fit to the aforementioned data for each specific source energy as a function of source position. In addition, a Monte Carlo radiation transport code was used to simulate the expected positionally variable response based solely upon radiation absorption. The simulated radiation transport efficiency functions were compared to the experimental data. The effects of the geometric radiation efficiency, the attenuation and scattering of emitted light within the scintillation crystal, and combined effects such as nonuniformity of the photomultiplier tube, photocathode response, and crystal irregularities were then distinguished. Functions describing each effect were derived. The results suggest potential new corrections to data obtained with large scintillation detectors as well as a novel approach to partial positional gamma-ray detection with minimal collimation, given that the energy resolution is within reason for particular photopeaks.

No abstract

Legacy Geiger-Muller (GM) survey meters recovered from fallout shelters have been used by several nuclear scientific societies as part of high school outreach programs. A donated antique instrument helps teachers demonstrate radiological principles, but fails to develop student's electronics skills, generate excitement for nuclear careers, or provide individuals with their own devices to explore the radioactive planet. A simple, affordable GM survey meter built by each student would increase direct engagement while providing hands-on experience with circuit-building, soldering, and computer programming. The inclusion of an affordable single-board computer as a component in the survey meter would enable students to tackle more various computer science and electronics projects, thereby potentially recruiting more students into technology and engineering. This paper details the challenges faced by an interdisciplinary undergraduate team designing an easy-to-assemble smart GM survey meter. Their iterative research, design, and testing process included modification to a basic circuit to enable use of different tube types, component cost reduction, application development, and data communication. The ultimate product of the team's efforts, a survey meter with affordable components and a smartphone application capable of creating radiation maps, is detailed in full.