Pressurized planar electrochromatography (PPEC) is a new planar chromatographic technique in which the mobile phase is driven by electroosmotic flow, while the sorbent layer is pressurized in a manner that allows heat to flow from the layer through an electrically insulating, thermally conducting, sheet of aluminum nitride ceramic. A prototype apparatus for performing PPEC is described. Separation by PPEC is faster than by conventional TLC, and an example is presented of a 24-fold enhancement in the speed of separation. PPEC was performed on both regular and high-performance C18 layers, and the latter yield substantially faster separation. The sorbent layer requires conditioning at elevated temperature before use, and solute migration velocity increases with this temperature. The flow rate increases in a linear manner with increasing voltage and diminishes in a nonlinear manner with increasing pressure. Both electrical current and Joule heating diminish with increasing pressure, and the diminution of flow at high pressure can be compensated by an increase in voltage. PPEC is more efficient than classical TLC. Theoretical plate heights diminish with increasing Rf and are in the range 29-21 and 55-27 microm for the high-performance and regular plates, respectively. PPEC retains the advantages of classical TLC but has the ability to separate a substantially higher number of samples simultaneously. An example is presented on the separation of nine samples in 1 min on a 2.5 cm x 10 cm sorbent layer.

We have investigated the effect of physical properties of 30 nonaqueous solvents on the specificity of Subtilisin Carlsberg for nucleophiles in the transesterification of N-acetyl-l-phenylalanine ethyl ester by methanol, 1-propanol, and 1-butanol at fixed thermodynamic water activity. In organic solvents, enzyme activity and nucleophile specificity are solvent-dependent, while in supercritical fluoroform, the activity and specificity are pressure-dependent. Losses in catalytic efficiency and substrate specificity are observed when subtilisin is exposed to hydrophilic organic solvents such as dioxane, tetrahydrofuran, and acetonitrile as compared to hydrophobic solvents (hexane and heptane). Log P is an important descriptor for correlating both the rate and the specificity of deacylation with solvent properties. A linear model of log initial rate against both log P and nonpolar unsaturated area provides the best two-variable fit to the data for solvents of high log P. A nonlinear model of specificity against log P provides the best fit for the complete data set. Correcting the activity for partitioning of nucleophilic substrates shows a similar trend for the intrinsic activity dependence of nucleophiles as a function of log P. In propane, under subcritical conditions, there is no significant effect of pressure on either the activity or the nucleophilic specificity of subtilisin. In fluoroform, however, where the physical properties of the solvent are pressure-dependent, the specificity of the enzyme is solvent density-dependent.

Pressurized planar electrochromatography (PPEC) is a fast and efficient planar chromatographic technique. The mobile phase is driven by electroosmotic flow, while the system is pressurized in a manner that allows heat to flow between the sorbent layer and the pressurizing medium. The reproducibility of solute retention was not satisfactory in the initial report describing PPEC. In the current report, this reproducibility is improved by better control of several experimental variables. The pressure at which PPEC is performed is now free of drift, and the temperature at which the layer is preconditioned is maintained to within +/-1 degrees C. The best reproducibility of retention is obtained when the plate is soaked in the mobile phase for a defined time before each run. In the original prototype, the temperature of the sorbent layer was not controlled. In the present apparatus, water, at a constant temperature between 3 and 60 degrees C, is circulated through channels in the two die blocks that pressurize the layer. The highest efficiency is obtained at an intermediate temperature. This behavior is ascribed to high resistance to mass transfer at the lower temperatures and increased diffusion at higher temperatures. Efficiency, as measured by the number of theoretical plates, increases with increasing migration distance. The height equivalent of a theoretical plate diminishes with increasing migration distance, and values as low as 0.0106 mm are obtained under appropriate conditions. This extrapolates to 94 000 plates/m. Manual spotting was used in this report. Evidence is presented that substantially better efficiency would be obtained if the initial spot size were smaller. The efficiency of PPEC in its current form is illustrated by a chromatogram showing the separation of nine solutes in 2 min. PPEC was also performed with TLC plates in a back-to-back configuration, and this doubles the number of samples that can be simultaneously separated.

The rapid separation of mixtures of six peptides using porous polymer monolithic layers in electrophoresis and pressurized planar electrochromatography modes has been achieved. The separations in the former mode were performed on a generic hydrophobic poly(butyl methacrylate-co-ethylene dimethacrylate) layer with no ionizable functionalities and required 2 min. This layer also enabled the separation of three oligonucleotides. The separation in the pressurized planar electrochromatographic mode was carried out using a negatively charged layer prepared via cografting of 2-acrylamido-2-methyl-1-propanesulfonic acid and 2-hydroxyethyl methacrylate on top of the generic hydrophobic monolith and was completed in 1 min.