Pressurized planar electrochromatography (PPEC) is a new planar chromatographic technique in which the mobile phase is driven by electroosmotic flow, while the sorbent layer is pressurized in a manner that allows heat to flow from the layer through an electrically insulating, thermally conducting, sheet of aluminum nitride ceramic. A prototype apparatus for performing PPEC is described. Separation by PPEC is faster than by conventional TLC, and an example is presented of a 24-fold enhancement in the speed of separation. PPEC was performed on both regular and high-performance C18 layers, and the latter yield substantially faster separation. The sorbent layer requires conditioning at elevated temperature before use, and solute migration velocity increases with this temperature. The flow rate increases in a linear manner with increasing voltage and diminishes in a nonlinear manner with increasing pressure. Both electrical current and Joule heating diminish with increasing pressure, and the diminution of flow at high pressure can be compensated by an increase in voltage. PPEC is more efficient than classical TLC. Theoretical plate heights diminish with increasing Rf and are in the range 29-21 and 55-27 microm for the high-performance and regular plates, respectively. PPEC retains the advantages of classical TLC but has the ability to separate a substantially higher number of samples simultaneously. An example is presented on the separation of nine samples in 1 min on a 2.5 cm x 10 cm sorbent layer.

Pressurized planar electrochromatography (PPEC) is a fast and efficient planar chromatographic technique. The mobile phase is driven by electroosmotic flow, while the system is pressurized in a manner that allows heat to flow between the sorbent layer and the pressurizing medium. The reproducibility of solute retention was not satisfactory in the initial report describing PPEC. In the current report, this reproducibility is improved by better control of several experimental variables. The pressure at which PPEC is performed is now free of drift, and the temperature at which the layer is preconditioned is maintained to within +/-1 degrees C. The best reproducibility of retention is obtained when the plate is soaked in the mobile phase for a defined time before each run. In the original prototype, the temperature of the sorbent layer was not controlled. In the present apparatus, water, at a constant temperature between 3 and 60 degrees C, is circulated through channels in the two die blocks that pressurize the layer. The highest efficiency is obtained at an intermediate temperature. This behavior is ascribed to high resistance to mass transfer at the lower temperatures and increased diffusion at higher temperatures. Efficiency, as measured by the number of theoretical plates, increases with increasing migration distance. The height equivalent of a theoretical plate diminishes with increasing migration distance, and values as low as 0.0106 mm are obtained under appropriate conditions. This extrapolates to 94 000 plates/m. Manual spotting was used in this report. Evidence is presented that substantially better efficiency would be obtained if the initial spot size were smaller. The efficiency of PPEC in its current form is illustrated by a chromatogram showing the separation of nine solutes in 2 min. PPEC was also performed with TLC plates in a back-to-back configuration, and this doubles the number of samples that can be simultaneously separated.

Ion-molecule reactions provide a powerful tool for structural elucidation of ionized pharmaceutical analytes in tandem mass spectrometry. However, all previous interfaces for the introduction of reagents for ion-molecule reactions have utilized a single reagent approach. In this study, a multiported pulsed valve system was designed and characterized for rapid introduction of three neutral reagents into a linear quadrupole ion trap. Additionally, automatic triggering was used to allow for the introduction of the reagents on a chromatographic time scale. This system enables automatic, high throughput screening of complex mixtures by using at least three different ion-molecule reactions. Further, rapid testing of new neutral reagents is also possible.

Gas-phase ion/molecule reactions have been used extensively for the structural elucidation of organic compounds in tandem mass spectrometry. Reagents for ion/molecule reactions can be introduced into a mass spectrometer via a continuous flow apparatus or through a pulsed inlet system. However, most of these approaches enable the use of only a single reagent at a time. In this work, a multichannel pulsed-valve inlet system was developed for the rapid consecutive introduction of up to nine different reagents or reagent systems into a linear quadrupole ion trap mass spectrometer for diagnostic gas-phase ion/molecule reactions. Automated triggering of the pulsed valves enabled these experiments to be performed on the high-performance liquid chromatography (HPLC) time scale. This enables high-throughput screening of several functionalities in analytes as they elute from an HPLC column.

No abstract