This paper exposes the Navigation and Control technology embedded in a recently commercialized micro Unmanned Aerial Vehicle (UAV), the AR.Drone, which cost and performance are unprecedented among any commercial product for mass markets. The system relies on state-of-the-art indoor navigation systems combining low-cost inertial sensors, computer vision techniques, sonar, and accounting for aerodynamics models.

Measurement of muscle strength and activity of upper limbs of non-ambulant patients with neuromuscular diseases is a major challenge. ActiMyo® is an innovative device that uses magneto-inertial sensors to record angular velocities and linear accelerations that can be used over long periods of time in the home environment. The device was designed to insure long-term stability and good signal to noise ratio, even for very weak movements. In order to determine relevant and pertinent clinical variables with potential for use as outcome measures in clinical trials or to guide therapy decisions, we performed a pilot study in non-ambulant neuromuscular patients. We report here data from seven Duchenne Muscular Dystrophy (DMD) patients (mean age 18.5 ± 5.5 years) collected in a clinical setting. Patients were assessed while wearing the device during performance of validated tasks (MoviPlate, Box and Block test and Minnesota test) and tasks mimicking daily living. The ActiMyo® sensors were placed on the wrists during all the tests. Software designed for use with the device computed several variables to qualify and quantify muscular activity in the non-ambulant subjects. Four variables representative of upper limb activity were studied: the rotation rate, the ratio of the vertical component in the overall acceleration, the hand elevation rate, and an estimate of the power of the upper limb. The correlations between clinical data and physical activity and the ActiMyo® movement parameters were analyzed. The mean of the rotation rate and mean of the elevation rate appeared promising since these variables had the best reliability scores and correlations with task scores. Parameters could be computed even in a patient with a Brooke functional score of 6. The variables chosen are good candidates as potential outcome measures in non-ambulant patients with Duchenne Muscular Dystrophy and use of the ActiMyo® is currently being explored in home environment.Trial Registration: ClinicalTrials.gov NCT01611597

Abstract-We address the problem of three-axis sensor calibration. Our focus is on magnetometers. Usual errors (misalignment, non-orthogonality, scale factors, biases) are accounted for. We consider a method where no specific calibration hardware is required. We solely use the fact that the norm of the sensed field must remain constant irrespective of the sensors orientation. The proposed algorithm is iterative. Its convergence is studied. Experiments conducted with MEMS sensors (magnetometers) stress the relevance of the approach.

International audienceWe address the problem of position estimation for a rigid body using an inertial measurement unit (IMU) and a set of spatially distributed magnetometers. We take advantage of the magnetic field disturbances usually observed indoors. This is particularly relevant when GPS is unavailable (e.g. during military operations in urban areas). We illustrate our technique with several experimental results obtained with a Kalman filter. We also present our testing bench which consists of low cost sensors (IMU and magnetometers)

Current outcomes in neuromuscular disorder clinical trials include motor function scales, timed tests, and strength measures performed by trained clinical evaluators. These measures are slightly subjective and are performed during a visit to a clinic or hospital and constitute therefore a point assessment. Point assessments can be influenced by daily patient condition or factors such as fatigue, motivation, and intercurrent illness. To enable home-based monitoring of gait and activity, a wearable magneto-inertial sensor (WMIS) has been developed. This device is a movement monitor composed of two very light watch-like sensors and a docking station. Each sensor contains a tri-axial accelerometer, gyroscope, magnetometer, and a barometer that record linear acceleration, angular velocity, the magnetic field of the movement in all directions, and barometric altitude, respectively. The sensors can be worn on the wrist, ankle, or wheelchair to record the subject's movements during the day. The docking station enables data uploading and recharging of sensor batteries during the night. Data are analyzed using proprietary algorithms to compute parameters representative of the type and intensity of the performed movement. This WMIS can record a set of digital biomarkers, including cumulative variables, such as total number of meters walked, and descriptive gait variables, such as the percentage of the most rapid or longest stride that represents the top performance of patient over a predefined period of time.