The purpose of this study was to evaluate the reliability of programming the articulator using the radiographs and the interocclusal records made during Jaw relation (Arrow point tracing) and Try-in stage. The study comprised of 15 edentulous subjects with well formed maxillary and mandibular ridges, with no signs and symptoms of temporomandibular joint disorders and neuromuscular disorders. Digital Orthopantomograph was taken for all the subjects. The condylar guidance angles were traced on Orthopantomograph for right and left sides and the values were recorded. The protrusive interocclusal records were made at jaw relation stage and at try-in stage using bite registration paste (Bitrex- vinyl polysiloxane) for all subjects. These interocclusal records were used to programme the Semi-adjustable articulator (Hanau Wide Vue) and the condylar guidance values on the right and left sides were recorded. The condylar guidance values so obtained were compared with the values obtained by Orthopantomograph. The condylar guidance values obtained by the various procedures were subjected to statistical analysis. The results showed statistically significant difference between the condylar guidance values obtained from Orthopantomograph (Radiograph) and the condylar guidance values obtained at the stage of jaw relation and also between Orthopantomograph and condylar guidance values obtained at the stage of Try-in. Condylar guidance values obtained from the Radiographs were higher than those obtained at the stage of Jaw relation and at the stage of Try-in. However, we notice that the mean condylar guidance values obtained at the stage of Try-in were nearer to the mean condylar guidance values obtained on the Radiographs.

A rare case of hereditary disturbance of dentine, Dentin dysplasia type I is presented, which is characterized by short or total absence of roots, obliterated pulp chambers, and peri-apical radiolucencies. It affects both primary and secondary dentition. Management of patients with dentinal dysplasia is difficult and requires a multidisciplinary approach. An overview of dentin dysplasia and its management along with a case report is discussed.

The study was undertaken to evaluate the parallelism between hamular-incisive-papilla plane (HIP) and the Campers plane. And to determine which part of the posterior reference of the tragus i.e., the superior, middle or the inferior of the Camper's plane is parallel to HIP using digital lateral cephalograms. Fifty edentulous subjects with well formed ridges were selected for the study. The master casts were obtained using the standard selective pressure impression procedure. On the deepest point of the hamular notches and the centre of the incisive papilla stainless steel spherical bearings were glued to the cast at the marked points. The study templates were fabricated with autopolymerizing acrylic resin. The subjects were prepared for the lateral cephalograms. Stainless steel spherical bearings were adhered to the superior, middle, inferior points of the tragus of the ear and inferior border of the ala of the nose using surgical adhesive tape. The subjects with study templates were subjected to lateral cephalograms. Cephalometric tracings were done using Autocad 2010 software. Lines were drawn connecting the incisive papilla and hamular notch and the stainless steel spherical bearings placed on the superior, middle and inferior points on the tragus and the ala of the nose i.e., the Campers line S, Campers line M, Campers line I. The angles between the three Camper's line and the HIP were measured and recorded. Higher mean angulation was recorded in Campers line S -HIP (8.03) followed by Campers line M-HIP (4.60). Campers line I-HIP recorded the least angulation (3.80). The HIP is parallel to the Camper's plane. The Camper's plane formed with the posterior reference point as inferior point of the tragus is relatively parallel to the HIP.

No abstract