Molecular dyads based on polycyclic electron donor (D) and electron acceptor (A) units represent suitable building blocks for forming highly ordered, solution‐processable, nanosegregated D‐A domains for potential use in (opto)electronic applications. A new dyad, based on alkyl substituted hexa‐peri‐hexabenzocoronene (HBC) and perylene monoimide (PMI) separated by an ethinylene linker, is shown to have a high tendency to self‐assemble into ordered supramolecular arrangements at multiple length scales: macroscopic extruded filaments display long‐range crystalline order, nanofiber networks are produced by simple spin‐coating, and monolayers with a lamellar packing are formed by physisorption at the solution‐HOPG interface. Moreover, highly uniform mesoscopic ribbons bearing atomically flat facets and steps with single‐molecule heights self‐assemble upon solvent‐vapor annealing. Electrical measurements of HBC‐PMI films and mesoscopic ribbons in a transistor configuration exhibit ambipolar transport with well balanced p‐ and n‐type mobilities. Owing to the increased level of order at the supramolecular level, devices based on ribbons show mobility increases of more than one order of magnitude.

Metropolis Monte Carlo simulations are used to construct minimal energy configurations by electrostatic coupling of rotating dipoles associated with each unit cell of a perovskite CH3NH3PbI3 crystal. Short-range antiferroelectric order is found, whereas at scales of 8-10 nm, we observe the formation of nanodomains, strongly influencing the electrostatics of the device. The models are coupled to drift-diffusion simulations to study the actual role of nanodomains in the I-V characteristics, especially focusing on charge separation and recombination losses. We demonstrate that holes and electrons separate into different nanodomains following different current pathways. From our analysis we can conclude that even antiferroelectric ordering can ultimately lead to an increase of photoconversion efficiencies thanks to a decrease of trap-assisted recombination losses and the formation of good current percolation patterns along domain edges.

We describe a systematic study on the influence of different experimental conditions on the Kelvin probe force microscopy (KPFM) quantitative determination of the local surface potential (SP) of organic semiconducting nanostructures of perylene‐bis‐dicarboximide (PDI) self‐assembled at surfaces. We focus on the effect of the amplitude, frequency, and phase of the oscillating voltage on the absolute surface potential value of a given PDI nanostructure at a surface. Moreover, we investigate the role played by the KPFM measuring mode employed and the tip–sample distance in the surface potential mapping by lift‐mode KPFM. We define the ideal general conditions to obtain a reproducible quantitative estimation of the SP and we find that by decreasing the tip–sample distance, the area of substrate contributing to the recorded SP in a given location of the surface becomes smaller. This leads to an improvement of the lateral resolution, although a more predominant effect of polarization is observed. Thus, quantitative SP measurements of these nanostructures become less reliable and the SP signal is more unstable. We have also devised a semi‐quantitative theoretical model to simulate the KPFM image by taking into account the interplay of the different work functions of tip and nanostructure as well as the nanostructure polarizability. The good agreement between the model and experimental results demonstrates that it is possible to simulate both the change in local SP at increasing tip–sample distances and the 2D potential images obtained on PDI/highly oriented pyrolytic graphite samples. These results are important as they make it possible to gain a quantitative determination of the local surface potential of π‐conjugated nanostructures; thus, they pave the way towards the optimization of the electronic properties of electroactive nanometer‐scale architectures for organic (nano)electronic applications.