No abstract

In the first part of this series of papers, the tensile properties of microcellular foams of polystyrene (PS), styrene‐acrylonitrile copolymer (SAN), and polycarbonate (PC) were reported. In this part, the impact properties of unnotched, sharply and bluntly notched samples of microcellularly foamed PS and SAN samples were studied. Furthermore, the effects of the sharpness of the notch as well as of the speed of the test were studied by comparing the impact tests with the single‐edge‐notched (SEN) tensile tests, which were carried out for the PS, SAN, and PC sample. Some limited improvement in impact and SEN tensile properties was exhibited in some experimental conditions. The impact properties of microcellularly foamed PC samples are reported elsewhere.

A new reaction system for the highly selective, hydrobromic acid catalyzed conversion of lactide into acrylic acid under mild conditions is reported. The applied liquid reaction system consists of a temperature-stable bromide-containing ionic liquid and 2-bromopropionic acid as a source of dry HBr, with no volatile organic solvent being used. This allows for the in situ removal of the formed acrylic acid, leading to an unmatched acrylic acid selectivity of over 72 % at full lactide conversion. Accounting for leftover reaction intermediates on the way to acrylic acid, which could be recycled in an elaborate continuous process, the proposed reaction system shows potential for acrylic acid yields well above 85 % in the liquid phase. This opens new avenues for the effective conversion of biogenic lactic acid (e.g., obtained by fermentation from starch) to acrylic acid. The resulting bio-acrylic acid is a highly attractive product for, for example, the diaper industry, where we expect consumers to be especially sensitive to aspects of sustainability.

An estimated 6.3 billion metric tons of post-consumer polymer waste has been produced, with the majority (79%) in landfills or the environment. Recycling methods that utilize these waste polymers could attenuate their environmental impact. For many polymers, recycling via mechanical processes is not feasible and these materials are destined for landfills or incineration. One salient example is the superabsorbent material used in diapers and feminine hygiene products, which contain crosslinked sodium polyacrylates. Here we report an open-loop recycling method for these materials that involves (i) decrosslinking via hydrolysis, (ii) an optional chain-shortening via sonication, and (iii) functionalizing via Fischer esterification. The resulting materials exhibit low-to-medium storage and loss moduli, and as such, are applicable as general-purpose adhesives. A life cycle assessment demonstrates that the adhesives synthesized via this approach outcompete the same materials derived from petroleum feedstocks on nearly every metric, including carbon dioxide emissions and cumulative energy demand.

The attachment of waterborne pathogens onto surfaces can be increased by coating the surfaces with positive charge-enhancing polymers. In this paper, the increased efficacy of polydiallyldimethylammonium chloride (p-DADMAC) coatings on glass was evaluated in a parallel plate flow chamber with the use of waterborne pathogens (Raoultella terrigena, Escherichia coli, and Brevundimonas diminuta). p-DADMAC coatings strongly compensated the highly negative charges on the glass surface and even yielded a positively charged surface when applied from a 500 ppm solution. Whereas none of the strains adhered from water to glass due to electrostatic repulsion, R. terrigena and E. coli readily adhered in high numbers to p-DADMAC coated glass slides applied from 1, 100, or 500 ppm aqueous solutions. B. diminuta only adhered to a positively charged p-DADMAC coating applied from a 500 ppm solution. In addition, all p-DADMAC coatings indicated strong contact killing with the bacterial species used in this study by live/dead staining techniques. In summary, this paper demonstrates the potential of p-DADMAC coatings to strongly enhance bacterial adhesion. Moreover, once adhered, bacterial viability can be reduced by the positively charged ammonium groups in the coating.