Our objective is to evaluate adequacy of water for consumption and irrigation. We collected nineteen water samples from 21 to 26, May 2017. Twenty-two physico-chemical and bacteriological parameters were taken into account, electrical conductivity, pH, total hardness, bicarbonate, nitrates, sulfates, chlorides, calcium, sodium, magnesium, potassium, dissolved oxygen and biochemical oxygen demand, chemical oxygen demand, total coliforms,

This experimental study describes the effect of the oscillating grid on hydrodynamics and mass transfer in an aquarium. The contribution of the two driving elements CO2 and oscillating grid is identified. Depending on the operating conditions, either these two effects add up and promote the circulation and transport of the liquid, or these effects are opposite, the liquid velocity is then reduced. On the other hand, with regard to gas-liquid mass transfer, the use of the grid is beneficial since, under certain operating conditions; the mass transfer coefficient is increased compared to that obtained without the grid. Analysis of the various energy contributions in the unit shows that the presence of the grid is justified only in cases where the CO2 flow rate must remain low. Flow characterization was performed using Particle Image Velocimetry (PIV) technique. The results were compared with previous studies. In order to perform the concentration field measurements by planar laser induced fluorescence (PLIF) technique and simultaneous PIV and PLIF measurements, the test bench was modified. The observations of velocity and concentration fields are in adequacy with the previous studies and allow to validate the bench. The necessary tools have been put in place, the study of mass transfer can continue.

Water purification by foaming in a bubble column is a major challenge for research. It leads to the development of innovative airlift column operated under depression. Sea water clarification by bubble column is well documented, but for freshwater remains insufficiently studied. Extraction of suspended clay particles in freshwater is carried out in an airlift column. The system used is under depression and operates in a closed circuit, thanks to a recirculation tank. Methyl isobutyl carbinol (MIBC) and soluble casein are used as surfactants to allow extraction. Clay used is fine and ultra-ventilated and a turbidimeter is used to measure turbidity. This study showed that the combined use of methyl isobutyl carbinol and casein in the airlift column makes it possible to completely clarify water loaded with clay particles. A turbidity of less than 1 NTU is obtained after 30 minutes of extraction.

The objective of this work research is to investigate the potential of using metallic powder mixed with electrical discharge machining (EDM) dielectric when machining hard electrically conductive materials. Nowadays, the development of industries requires hard materials for various applications. Machining the hard materials using the traditional processes lead to tool break and poor machined product. Even when the conventional EDM can machine hard material as long as it is electrically conductive materials, the machined parts still present drawbacks. Metallic powder mixed with EDM dielectric (PMEDM) was hypothesized to improve the machined part. The presence of metallic powder ensures uniform distribution of spark and the electrical density of the spark decreases which reduces craters, cracks and voids on machined surface. The transfer and deposit of alloying elements during powder mixed electrical discharge machining improve the machined surface properties particularly micro-hardness and fatigue. Discharge current (IP), gap voltage (GapV), ON-time (ON) and aluminum powder are selected as machined variable parameters and the output responses are fatigue performance, micro-hardness and surface topography. The workpiece material selected is molybdenum high speed steel. Micro-hardness was determined using micro-hardness tester device. The fatigue performance was determined using empirical equation. Analysis of material transfer was done using energy dispersive spectroscopy (EDS) attached to FESEM. EDS analysis involves the generation of an X-ray spectrum from the entire scan area of the SEM. The use of PMEDM improved the fatigue, the micro-harness and the machined surface morphology as the above-mentioned parameters increased.

No abstract