Sand production and sand control studies in non-diagenetic reservoirs are the weak point in the conventional petroleum industry. However, natural gas hydrate (NGH) mainly exists in non-diagenetic strata, and sand production occurs during exploitation, which restricts the safe and sustainable production of NGH. To study the microcosmic characteristics of sand production, the hydrate decomposition behaviours in the sediments were captured by the Cryo-SEM method. The micromorphology of different particle sizes of sand samples containing NGH (the sand median diameter d50 is 150, 87, 55, 38, 24, and 13 𝜇m) and the microcosmic processes of NGH decomposition were observed. Then, the microcosmic characteristics of sand production, during the decomposition process, were analysed. (1) The gas hydrate decomposition increases pore space and reduces reservoir strength; the expansion action of the decomposition of water and gas, the softening action of the decomposition of water, and the compression action by overlying stress (crustal stress) promoted sand production, deformation, and subsidence of the NGH reservoirs in the mining process. (2) The decomposition of NGH has a more significant impact on sediments with smaller particle sizes. (3) The particle size of NGH may be larger than the particle size of the mud in the reservoirs, and acting as “gravel” plays a particular role in sand control. Therefore, the particle size of NGH cannot be ignored in the design of sand control. (4) It has been revealed, and verified, that sputtering (splashing) is a unique process of sand production caused by NGH decomposition. In other words, the rapid expansion of the volume of the decomposed gas and water from NGH leads to the eruption and sputtering of hydrate particles, providing the driving force for sand migration, which is a different process of sand production than in conventional oil and gas.

Gas from natural gas hydrate (NGH) is priced competitively with gas prices. Most marine NGH is stored in low cementing strata, which easily cause sand production problems, restricting the commercial production and environmental safety of NGH’s development. This study applied a numerical simulation on sand production in hydrate-bearing sediments’ (HBS) exploitation. The numerical simulation on sand production was carried out for different productions of laboratory NGH exploitation. The results show radial strain appeared to be deformed away from the wellbore and show radial displacement close to the wellbore during mining. Due to the overburden stress condition, the boundary condition wall was a displace less rigid body. The radial displacement was greatly affected by depressurization, which showed the displacement to the wellbore and sanding. The radial strain was dominant by the shear shrinkage phenomenon in the mechanical model, while the reservoir’s radial displacement was away from the wellbore instead. The balance between the fluid driving force of production rates towards the wellbore and radial displacement drawing away from the wellbore is significant to sand production in HBS. The dominant forces of sanding were different mechanical and hydraulic combinations in three periods of GH production.