Green lasers with high efficiency are keystone components for mobile projectors. We demonstrate a miniature device (<0.7 cc volume) that utilizes adaptive optics for operation over a 50 °C temperature range without requiring a thermo‐electric cooler. The use of adaptive optics also helps in reducing the cost of the laser assembly.

We compare the transmission performance of three different optical fibers in separate 256 Gb/s PM-16QAM systems amplified with erbium doped fiber amplifiers (EDFAs) and distributed Raman amplification. The span length in each system is 100 km. The fibers studied include standard single-mode fiber, single-mode fiber with ultra-low loss, and ultra-low loss fiber with large effective area. We find that the single-mode fiber with ultra-low loss and the large effective area fiber with ultra-low loss afford reach advantages of up to about 31% and 80%, respectively, over standard fiber measured at distances with 3 dB margin over the forward error correction (FEC) threshold. The Raman amplified systems provide about 50% reach length enhancement over the EDFA systems for all three fibers in the experimental set-up. For the best performing fiber with large effective area and ultra-low loss, the absolute reach lengths with 3 dB margin are greater than 1140 km and 1700 km for the for EDFA and Raman systems, respectively.

Abstract— Efficient and compact green lasers are keystone components for micro‐projector applications in mobile devices. An architecture that consists of an infrared‐producing DBR (distributed Bragg reflector) laser with a frequency‐doubling crystal is used to synthesize a green laser that has high electrical‐to‐optical conversion efficiency and can be modulated at speeds required for scanner‐based projectors. The design and performance of a green‐laser package that uses adaptive optics to overcome the challenge of maintaining alignment between the waveguides of the DBR laser and the frequency‐doubling crystal over temperature and lifetime is described. The adaptive optics technology that is employed uses the piezo‐based smooth impact drive mechanism (SIDM) actuators that offer a very small step size and a range of travel adequate for the alignment operation. The laser is shown to be compact (0.7 cm3 in volume) and capable of a wall‐plug efficiency approaching 10% (at 100‐mW green power). It was demonstrated that the adaptive optics enables operation over a wide temperature range (10–60°C) and provides the capability for low‐cost assembly of the device.

No abstract

We study unrepeatered transmission of 40x256 Gb/s systems with polarization-multiplexed 16-quadrature amplitude modulation (PM-16QAM) channels using simple coherent optical system configurations. Three systems are investigated with either a homogeneous fiber span, or simple two-segment hybrid fiber designs. Each system relies primarily on ultra-low loss, very large effective area fiber, while making use of only first-order backward pumped Raman amplification and no remote optically pumped amplifier (ROPA). For the longest span studied, we demonstrate unrepeatered 256 Gb/s transmission over 304 km with the additional aid of nonlinear compensation using digital backpropagation. We find an average performance improvement in terms of the Q-factor of 0.45 dB by using digital backpropagation compared to the case of using chromatic dispersion compensation alone for an unrepeatered span system.