Light Detection and Ranging (LIDAR) is a remote sensing technique that measures properties of backscattered light in order to obtain information of a distant target. This work presents a method to improve the signal-to-noise ratio by 8 dB with respect to the direct detection of the backscattered signal of a LIDAR system. This method consists of the measurement of the Fourier coefficients of the LIDAR signal, which is possible thanks to the novel coupling of a sequential equivalent time base sampling (SETS) circuit and a conventional lock-in amplifier that allows to measure the Fourier coefficients of the LIDAR signal, the results are comparable to noise elimination using Empirical Mode Decomposition. The feasibility of the proposal is demonstrated experimentally with mist. The method can be used to different applications of elastic-scattering LIDAR under the conditions of the devices for applied the phase sensitive detection.

An experiment is described where two-dimensional small-angle light scattering (2D-SALS) patterns from single particles are measured in the infrared through a lens-free approach. Spatial filtering is employed to separate scattered light from unscattered light to within approximately one degree from the forward direction. Non-planar reflective elements are used in the filtering process, permitting 2D-SALS measurements to be done without chromatic aberrations over a broad spectral range and from 0.8 to 8 degrees in the polar scattering angle and zero to 360 degrees in the azimuthal angle. Patterns from spherical microparticles are presented along with nonspherical particles including volcanic ash and salt. An asymmetry analysis is applied to demonstrate an ability to differentiate spherical from nonspherical particles from the 2D-SALS patterns.

Background: In this work, the experimental behavior observed in the z-scan curves of a sample of bleached photographic film for different incident powers is theoretically modeled. Methods: Two models are modified in order to fit the experimental z-scan curves. The Focal Length Dependent on a power of the beam radius (FLD) model and the Nonlocal (NL) model. Results: As a result of the fitting, it is not possible to fit the experimental results considering only one contribution during the z-scan experiment. Conclusion:The results demonstrated that two contributions were needed to reproduce completely the experimental z-scan curves in both models.

Using a supercontinuum laser, reflective optics, and a spatial filter, we measure two-dimensional small-angle light-scattering patterns for a variety of microparticles including spheres, salt, sand, and volcanic dust. The measurements are done at 13 wavelengths from 450–850 nm, where the absence of refractive optical elements minimizes the effects of chromatic aberration. Qualitative particle-material sensitivity is demonstrated by layering differently colored patterns. Last, the multispectral capability of our device demonstrates a new possibility to probe different q -space regimes for a given particle in a single measurement.

No abstract