This paper presents two approaches to characterize RF circuits with built-in differential temperature measurements, namely the homodyne and heterodyne methods. Both non-invasive methods are analyzed theoretically and discussed with regard to the respective trade-offs associated with practical off-chip methodologies as well as on-chip measurement scenarios. Strategies are defined to extract the center frequency and 1 dB compression point of a narrow-band LNA operating around 1 GHz. The proposed techniques are experimentally demonstrated using a compact and efficient on-chip temperature sensor for built-in test purposes that has a power consumption of 15 μW and a layout area of 0.005 mm 2 in a 0.25 μm CMOS technology. Validating results from off-chip interferometer-based temperature measurements and conventional electrical characterization results are compared with the on-chip measurements, showing the capability of the techniques to estimate the center frequency and 1 dB compression point of the LNA with errors of approximately 6% and 0.5 dB, respectively.

The observation of spectral components of the power dissipated by devices and circuits in integrated circuits (IC) by temperature measurements is limited by the bandwidth of either the temperature transducer or the intrinsic cut-off frequency provided by the thermal coupling inside the chip. In this paper, we use a heterodyne method to observe the high-frequency behavior of circuits and devices by means of low-frequency lock-in temperature measurements. As experimental results, two applications of the technique are presented: detection of hot spots in ICs activated by high-frequency electrical signals and the observation of the frequency response of an integrated resistor through temperature measurements. The heterodyne method has been used in this paper with four different measurement techniques: embedded differential BiCMOS temperature sensor, laser reflectometer, laser interferometer and internal IR laser deflection meter.

No abstract

The focus in this paper is on the extraction of RF circuit performance characteristics from the dc output of an on-chip temperature sensor. Any RF input signal can be applied to excite the circuit under examination because only dissipated power levels are measured, which makes this approach attractive for online thermal monitoring and built-in test scenarios. A fully differential sensor topology is introduced that has been specifically designed for the proposed method by constructing it with a wide dynamic range, programmable sensitivity to dc, and RF power dissipation, as well as compatibility with CMOS technology. This paper also presents an outline of a procedure to model the local electrothermal coupling between heat sources and the sensor, which is used to define the temperature sensor's specifications as well as to predict the thermal signature of the circuit under test.A prototype chip with an RF amplifier and temperature sensor was fabricated in a conventional 0.18-m CMOS technology. The proposed concepts were validated by correlating RF measurements at 1 GHz with the measured dc voltage output of the on-chip sensor and the simulation results, demonstrating that the RF power dissipation can be monitored and the 1-dB compression point can be estimated with less than 1-dB error. The sensor circuitry occupies a die area of 0.012 mm , which can be shared when several on-chip locations are observed by placement of multiple temperature-sensing parasitic bipolar devices.Index Terms-CMOS temperature sensor, differential temperature sensing, electrothermal coupling, electrothermal IC design, homodyne measurement method, low-noise amplifier (LNA), on-chip temperature gradient measurement, radio frequency (RF) built-in test (BIT), radio frequency (RF) power detector.

No abstract