Gold/one-dimensional photonic crystal (Au/1D-PC) is fabricated and applied for sensitive sensing of glucose and different chemical molecules of various refractive indices. The Au layer thickness is optimized to produce surface plasmon resonance (SPR) at the right edge of the photonic band gap (PBG). As the Au deposition time increased to 60 sec, the PBG width is increased from 46 to 86 nm in correlation with the behavior of the SPR. The selectivity of the optimized Au/1D-PC sensor is tested upon the increase of the environmental refractive index of the detected molecules. The resonance wavelength and the PBG edges increased linearly and the transmitted intensity increased nonlinearly as the environment refractive index increased. The SPR splits to two modes during the detection of chloroform molecules based on the localized capacitive coupling of Au particles. Also, this structure shows high sensitivity at different glucose concentrations. The PBG and SPR are shifted to longer wavelengths, and PBG width is decreased linearly with a rate of 16.04 Å/(μg/mm3) as the glucose concentration increased. The proposed structure merits; operation at room temperature, compact size, and easy fabrication; suggest that the proposed structure can be efficiently used for the biomedical and chemical application.

Thermoacoustic heat engines provide a practical solution to the problem of heat management in microcircuits where they can be used to pump heat or produce spot cooling of specific circuit elements. There are basically two types of thermoacoustic engines, a prime mover where heat is converted to acoustic energy, and a heat pump or cooler where sound can pump heat up a temperature gradient. Such devices are relatively simple, they can be efficient, and they are readily adaptable to microcircuit interfacing. Since this type of engines is usually operated in a resonant mode, the operating frequency determines its size. The devices presented here are pumped at frequencies ranging from 4 to 24 kHz. They have been developed for interfacing with microcircuits as heat pumps or spot coolers. Results of their performance are presented and suggestions for further improvements are discussed. q

The optical transmission properties of two types of photonic crystals have been analyzed by using the transfer matrix method. The first one is the dielectric photonic crystal (DPC), and the second is the metallic photonic crystal (MPC). We found the dielectric and metallic photonic crystals have different transmission spectra. The effect of the most parameters on the transmission spectra of the dielectric and metallic photonic crystals has been studied.

In this work, we have introduced a comprehensive study concerning with the effects of some physical parameters on the dispersive properties of 1D phononic crystal (PnC). We have treated the propagation of elastic (in-plane) waves incident normally on 1D PnC. Based on the transfer matrix method, the reflection coefficients are calculated and plotted for the plane waves. We have studied many physical parameters effects on the properties of PnCs such as type of surrounding material, type of composites materials, temperature and propagation of waves in defect structures. Also the phenomenon of local resonance was discussed in this survey. These results can be useful in many applications such as sound suppressions and temperature sensor materials.

No abstract